Installation Instructions

IMPORTANT:

The fixture features a photocell sensor which enables the light to turn on at dusk and off at dawn automatically.

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. Customer Service: 1-800-887-6326 (weekdays 9 a.m. – 5 p.m. CST)

3. READ AND SAVE THESE INSTRUCTIONS.

356-9216 / 356-9217

Patriot Lighting

140515

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

Note: Fixture can be wall mounted or eave mounted.

Wall Mounted

Eave Mounted

Light fixture should be mounted as shown above when installed (depending upon type of installation)

FRONT

Turn off the power at fuse or circuit box.

1. The mounting bracket is pre-assembled on the light fixture, unscrew the decorative cover, fixture mounting screw and

remove the mounting bracket.

2. Install the mounting strap with the stamped word “FRONT” facing away from the

outlet box, using two mounting screws that best fit the outlet box.

Fixture Mounting Screw

Mounting Strap

Mounting Bracket

Outlet Box

Wire Nut

Back Plate

Mounting Screw

Light Head

Fixture Mounting Screw

Mounting Bracket Screw

Decorative cover

Hardware Package (included):

Mounting Screw X2

Decorative cover

Mounting Bracket Screw

Fixture Mounting Screw

Mounting StrapMounting Screw X2

Wire Nut X3

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS 356-9216 / 356-9217 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. Customer Service: 1-800-887-6326 (weekdays 9 a.m. – 5 p.m. CST) 3. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
3. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows: ---Connect the black wire from the fixture to the black wire from the power source. ---Connect the white wire from the fixture to the white wire from the power source. ---Connect the grounding wire from the fixture to the grounding wire from the power source. (usually green / yellow insulation) Carefully tuck the wires back into the outlet box. 4.