Installation Instructions

ManualsBrandsPatriot Lighting ManualsLighting & Ceiling FansWhite Dual Head Motion Sensor Outdoor Security Flood Light

Questions, problems, missing parts?

Before returning to your retailer, call our customer service at 1-800-887-6326

Monday – Friday 9:00 a.m. – 5:00 p.m. CST

Sku Number: 356-9235

356-9236

OUTDOOR SENSOR LIGHT

Model Number: ow9235w

ow9236bz

Page 1 of 6

HARDWARE CONTENTS Note: Hardware not shown actual size.

Mounting Screw

Wire Connector

Cross Bar

PACKAGE CONTENTS

Decorative cover

Fixture Mounting Screw

Gasket

Summary of content (6 pages)

PAGE 1
Sku Number: 356-9235 356-9236 OUTDOOR SENSOR LIGHT Model Number: ow9235w ow9236bz Questions, problems, missing parts? Before returning to your retailer, call our customer service at 1-800-887-6326 Monday – Friday 9:00 a.m. – 5:00 p.m. CST PACKAGE CONTENTS D B A C HARDWARE CONTENTS Note: Hardware not shown actual size.
PAGE 2
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. WARNING • Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or switching off circuit breaker). • Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact any surface having a sharp edge.
PAGE 3
ASSEMBLY INSTRUCTIONS (continued) Before installing the light fixture under an eave, the sensor head must be rotated as shown in the next two steps for proper operation and to avoid the risk of electrical shock. For eave mounted only: Rotate the sensor head (C) clockwise 180˚ so the controls face down. Rotate the sensor head (C) towards the back plate . (A). Controls Controls TE A ST E 5S TIM 3M IN SE N SIT IV IT Y C C Controls Installation Steps 1.
PAGE 4
ASSEMBLY INSTRUCTIONS INSTRUCTIONS (continued) ASSEMBLY (continued) Adjusting the Sensor Head (C): 1. Aim sensor head (C) toward desired detection area, maintaining a 5° - 40° downward angle to allow moisture to drain. Note: Make sure sensor head (C) is positioned with controls facing toward the ground. 2. You can move the sensor head (C) up and down to change the coverage area. (See Fig. 1) Note: Range set too high may increase false triggering. (See Fig. 2 and Fig. 3 ) C Fig. 1 Fig. 2 Fig.
PAGE 5
FUNCTION AND OPERATION(continued) (continued) ASSEMBLY INSTRUCTIONS 2. AUTO MODE (nighttime operation only) ● To shift to the “AUTO” mode, rotate “TIME” knob arrow to the desired time setting (between 5 seconds and 3 minutes). At dusk, the light turns on when motion is detected, and stays on as long as motion continues. When the motion is no longer detected, the light remains on for the predetermined time you set (5s ~ 3min), and then turns off automatically. ● The light turns off automatically at dawn.
PAGE 6
FUNCTION AND OPERATION(continued) (continued) ASSEMBLY INSTRUCTIONS The following parts are available for re-order if damaged or missing. Call us toll-free at 1-800-887-6326. Spare Parts List: CC AA Decorative cover X1 Mounting Screw X2 BB EE Wire Connector X3 DD FF Fixture Mounting Screw X1 Cross Bar X1 Gasket X1 Assembly Kit 5351MM (1 SET) FOR 356-9235 5352MM (1 SET) FOR 356-9236 CARE AND MAINTENANCE Clean the glass and coated metal surfaces with a non-abrasive cleaner.