Installation Instructions

Page 4 of 5
Vintage Bulb Max.60W
8067EB
FF
Turn off the power at fuse or circuit box.
1. Attach mounting unit(AA) to the
outlet box using two mounting
screws(BB). Adjust the length of
long screws on the mounting
unit(AA) if necessary.
A
EE
2
3
Cable
Cable
Canopy
2. Cut off the cable near the bottom
of the adapter(A).
Follow step 1 as For TRACK
MOUNTING.
4
a
c(3")
d(3/8")
b(9")
3. Thread the cable through the
canopy and two holes of the
strain relief(EE).
Main Fixture
4. Measure the desired length of the
cable(a) from the canopy to the
top side of the main fixture and
leave an additional 9" of cable(b)
above the canopy (include the
canopy), and then cut off the
unnecessary cable.
Adjust strain relief at 9" position
from the top of the cable.
Mark the 3" of cable(c) from the
top of the cable(b). Use a knife to
peel off the insulation of the
cable(c) carefully to expose three
internal wires.
Note: Cutting too deep may cut off the internal
wires and destroy the insulation surface of the
internal wires.
Peel off the wires from the top about 3/8" long(d) to
expose the copper for wiring.
AA
DD
7. Attach the canopy to the mounting
unit(AA) by inserting the screws,
and then secure it with two bolt
nuts(DD).
7
Canopy
Canopy
Bolt Nut
X2
EE
DD
Mounting Unit
X1
Mounting Screw
X2
AA
BB
Wire Nut
X3
CC
Strain Relief
X1
Spare Parts List:
The following parts are available for re-order if damaged or missing. Call us toll-free at 1-800-887-6326
Assembly Kit
5719MM (1 SET)
5
EE
Hex Nut
5. Pull down the cable slightly until the
strain relief(EE) touches the hex nut.
ASSEMBLY INSTRUCTIONS FOR CEILING MOUNTING
8. Install a Vintage Bulb (FF)
Max.60W. (included)
Turn on the power at fuse or circuit
box.
CC AA
6
Vintage Bulb
Max.60W
(included)
FF
8
Cable
6. Pull out the source wires from the
outlet box. Make wire connections
using wire nuts(CC) as follows:
-- Connect the fixture black wire to
the house black wire using wire
nuts(CC) provided.
-- Connect the fixture white wire to
the house white wire using wire nuts(CC) provided.
-- Connect the bare grounding wire from the canopy to
the mounting unit(AA) by securing it with the
preinstalled grounding screw, and then connect it to
the fixture green grounding wire and the house
grounding wire with wire nuts(CC).
Tuck all the wires into outlet box.
AA
BB
1
Long Screw