Installation Instructions

1. Using 3.25” template
on the box, mark the
openings and cut the
openings with a drywall
saw where you intend to
install the lights. (Fig.1)
2. Pull wiring through
hole cut out. Using the
wire-nut, connect the
incoming and outgoing
wires by matching white
to white, black to black
and green to ground wire
and twist on. (Fig.2)
3. Lift the housing onto
the drywall. (Fig.3)
349-0004
349-0006
349-0007
349-0008
03/16
INSTALLATION:
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE
BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
3. CAUTION – RISK OF FIRE. CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH
CIRCUIT CONDUCTOR.
4. CONNECT THE GROUND WIRE (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND
WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL OUTLET BOX.
5. DO NOT INSTALL INSULATION WITHIN 76 mm (3 inch) OF ANY PART OF THE LUMINAIRE.
NOTE: Product May Not Look Exactly As Shown In Figures.
RECESSED LIGHT
(FOR NON-INSULATED CEILING)
drywall saw
ceiling
(Fig.1)
3.25”
diameter hole
SAFETY PRECAUTIONS:
!
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
white
black
green ground
ceiling
housing
(Fig.2)
(Fig.3)
ceiling
4. Push to lock the two
remodel clips to hold the can
against the ceiling. (Fig.4)
5. Install specified bulb type
and wattage and trim. (Fig.5)
trim
bulb
bulb
housing
housing
(Fig.4)
(Fig.5)
trim
bulb
remodel
spring clip
TOOLS AND MATERIALS REQUIRED:
Blade
Screwdriver
Wire Cutters
Pliers Wrench
Saw
Wiring supplies
as required by
local electrical
code
QUESTIONS OR CONCERNS CONTACT PATRIOT AT: 1-800-267-4427 (English) / 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T. or email to: [e-mail]
KEEP PROTECTIVE
BARRIER IN PLACE.
socket