Installation Instructions

ManualsBrandsPatriot Lighting ManualsIndoor LightingAdam Bronze 1-Light LED Track Lighting Pendant

Questions, problems, missing parts?

Before returning to your retailer, call our customer service at 1-800-887-6326

Monday – Friday 9:00 a.m. – 5:00 p.m. CST

Sku Number: 349-0531

349-0533

DUAL MOUNT PENDANT

Model Number:TF0003

TF0065

PACKAGE CONTENTS

Page 1 of 5

Bolt Nut

Mounting Unit

Mounting Screw

Wire Nut

HARDWARE CONTENTS Note: Hardware not shown actual size.

Strain Relief

Canopy

“ L ” Screwdriver

Summary of content (5 pages)

PAGE 1
Sku Number: 349-0531 349-0533 DUAL MOUNT PENDANT Model Number:TF0003 TF0065 Questions, problems, missing parts? Before returning to your retailer, call our customer service at 1-800-887-6326 Monday – Friday 9:00 a.m. – 5:00 p.m. CST PACKAGE CONTENTS A B C D HARDWARE CONTENTS Note: Hardware not shown actual size.
PAGE 2
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. WARNING ● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or switching off circuit breaker). ● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact any surface having a sharp edge.
PAGE 3
ASSEMBLY INSTRUCTIONS FOR TRACK MOUNTING (continued) To Shorten the Cable of the Pendant (If in doubt, consult a qualified electrician) 1.Loosen the lower headless screw, 1 using supplied “ L ” screwdriver(GG), and then remove the cover(D) from tube(C). C GG Headless Screw D 2. Tear off the electrical tape, and then unscrew the wire nuts to separate the wires. 2 C Wire Nut D 3. Adjust the length of the cable: a.) Measure the desired length of cable and mark "A"; Slide cover(D) down past "A".
PAGE 4
ASSEMBLY INSTRUCTIONS FOR CEILING MOUNTING Turn off the power at fuse or circuit box. 1. Attach mounting unit(AA) to the outlet box using two mounting screws(BB). Adjust the length of long screws on the mounting unit(AA) if necessary. 5. Pull down the cable slightly until the 5 strain relief(EE) touches the hex nut. 1 AA BB Long Screw 2. Cut off the cable near the bottom of the cover(D). Cable 2 D Cable 3. Thread the cable through the canopy and two holes of the strain relief(EE).
PAGE 5
CARE AND MAINTENANCE ● To clean, turn off and wipe with a damp, non-abrasive cloth. TROUBLESHOOTING 1) The light does not come on at all: a) Make sure the wall switch and circuit breaker are on. b) Make sure the wiring is correct. c) Check for loosen or disconnected wires in light. d) Check that the connection between the adapter and the rail is correct. 2) Fuse blows or circuit trips when light is turned on. a) Check for crossed wires, ensure wiring is correct.