Installation Instructions

Page 4 of 5
ASSEMBLY INSTRUCTIONS FOR CEILING MOUNTING
Turn off the power at fuse or circuit box.
D
1. Attach mounting unit(AA) to the
outlet box using two mounting
screws(BB). Adjust the length of
long screws on the mounting
unit(AA) if necessary.
2
Cable
2. Cut off the cable near the bottom
of the cover(D).
AA
DD
7. Attach the canopy to the mounting
unit(AA) by inserting the screws,
and then secure it with two bolt
nuts(DD).
Turn on the power at fuse or circuit
box.
7
Canopy
Bolt Nut
X2
EE
DD
Mounting Unit
X1
Mounting Screw
X2
AA
BB
Wire Nut
X3
CC
Strain Relief
X1
Spare Parts List:
The following parts are available for re-order if damaged or missing. Call us toll-free at 1-800-887-6326
Assembly Kit
5708MM (1 SET) FOR 349-0531
5709MM (1 SET) FOR 349-0533
EE
3
Cable
Canopy
4
a
c(3")
d(3/8")
b(9")
3. Thread the cable through the
canopy and two holes of the
strain relief(EE).
Main Fixture
4. Measure the desired length of the
cable(a) from the canopy to the
top side of the main fixture and
leave an additional 9" of cable(b)
above the canopy (include the
canopy), and then cut off the
unnecessary cable.
Adjust strain relief at 9" position
from the top of the cable.
Mark the 3" of cable(c) from the
top of the cable(b). Use a knife to
peel off the insulation of the
cable(c) carefully to expose
three internal wires.
Note: Cutting too deep may cut off the internal wires
and destroy the insulation surface of the internal
wires.
Peel off the wires from the top about 3/8" long(d) to
expose the copper for wiring.
Canopy
5
EE
Hex Nut
5. Pull down the cable slightly until the
strain relief(EE) touches the hex nut.
Cable
GG
“ L ” Screwdriver
X1
AA
BB
1
Long Screw
CC AA
6
6. Pull out the source wires from the
outlet box. Make wire connections
using wire nuts(CC) as follows:
-- Connect the fixture hot wire
(black wire or black stripe inside)
to the house black wire using
wire nuts(CC) provided.
-- Connect the fixture neutral wire (white wire or white
stripe inside) to the house white wire using wire
nuts(CC) provided.
-- Connect the bare grounding wire from the canopy to
the mounting unit(AA) by securing it with the
preinstalled grounding screw, and then connect it to
the fixture grounding wire (green wire or green stripe
inside) and the house grounding wire with wire nuts(CC).
Tuck all the wires into outlet box.
FF
Canopy
X1