Installation Instructions

INSTRUCTIONS

FOR ITEM: 349-5906 (Track is sold separately)

WARNIGN: To avoid the risk of injury, be sure to turn off electrical power

while installing or servicing this fixture.

1-2 To mount Track, drill holes in ceiling or wall. Attach Track with toggle bolts or screws if surface is

solid material.

Track mounting holes

Plain underside of Track faces ceiling or wall

Open,slotted side of Track faces OUT to accept lights

Dead end fitting with set screw

CAUTION: Turn off switch at main power source (fuse box) before installing any Track or fittings.

STEP 1. Place Track over outlet box and mark position of Track mounting holes on ceiling or wall. On

wallboard or plaster, drill 5/8" mounting holes and install Track to ceiling or wall using toggle bolts. On

wood surfaces, use standard dry wall screws.

STEP 2. Install mounting adapter and power fittings.

STEP 3. Switch on main power.

CAUTION: Disconnect power before installation.

To attach mounting adapter to the Track, align the polarity lines of the Track and the polarity lines of

the mounting adapter. Push top portion of the adapter with contact fingers into the slot in the Track

and turn 90 (if the adapter does not turn easily, do not force, but turn in other direction.) To remove,

depress the release lever with the index finger and turn 90 .

Note: If the polarity lines of the Track and the polarity lines of the mounting adapter don't match, The

light bulb not bright.

MOUNTING ADAPTER INSTALLATION

ASSEMBLY INSTRUCTIONS

130902

MOUNTING ADAPTER

TRACK

POLARITY LINE

PAGE 1
INSTRUCTIONS FOR ITEM: 349-5906 (Track is sold separately) WARNIGN: To avoid the risk of injury, be sure to turn off electrical power while installing or servicing this fixture. ASSEMBLY INSTRUCTIONS CAUTION: Turn off switch at main power source (fuse box) before installing any Track or fittings. STEP 1. Place Track over outlet box and mark position of Track mounting holes on ceiling or wall. On wallboard or plaster, drill 5/8" mounting holes and install Track to ceiling or wall using toggle bolts.
PAGE 2
Track 1. Attach the adapter onto the track. See “MOUNTING ADAPTER INSTALLATION” for detail. 2. Attach the glass shades to the glass holders, secure them with a metal pad and socket rings, using supplied fixer. 3. Install bulbs (Included). a. Attach the cupule to the top surface of the halogen bulb lens. b. Insert and twist the bulb (GU10 BASE MR16C BULB ONLY) into the socket of the glass holder using the cupule. c. Remove the cupule from the halogen bulb lens by pulling the knob of the cupule.