Installation Instructions

If improper
ground tab has been
removed. DO NOT USE
connector since
grounding will not be
maintained.
WARNING:
Connector
Live end cover
removed
Nickel-plated
terminal
Set screw
Outlet Box
LIVE END W/ CANOPY
1. Punch out the knock-out hole in the back plate of live
end fitting.
Remove the flat head screw from the live end cover.
2. Remove cover from live end fitting. Place track with
ceiling plate attached over outlet box and mark on
ceiling or wall the position of the track mounting holes.
3. Insert the ceiling plate to the back of the track and fasten
the track.
4. Pull wires from box through the plate to the open hole in live end
as shown.
5. Loosen the set screw on live end and slide the live end into
the track. Secure the live end in the track with a set screw.
6. Cut and strip wires from box and fasten to screw terminals
in live end fitting (See detail). Push excess wires back
into outlet box. If ground wire is available, fasten
it to the green ground screw.
7. Replace cover on live end and tighten screw.
Black Wire
(Hot)
White Wire
(Neutral)
Ceiling plate
Strip bare 3/4"
Not necessary to wrap
wire around screw
Brass terminal
Green
ground
screw
Optional green
ground wire
Wires from outlet
box fit through center
hole of plate. then
into live end fitting.
Ground
conductor
side
Dead end
fitting
with set
screw
Set Screw
Track
Ground
conductor
Remove this tab
Ground tab
3496 4620