Installation Instructions

ManualsBrandsPatriot Lighting ManualsIndoor Lighting2000 Lumen 2' White Integrated LED Wrap Light

Questions, problems, missing parts?

Before returning to your retailer, call our customer service at 1-855-508-3883

Monday – Friday 9:00 a.m. – 5:00 p.m. CST

Page 1 of 4

HARDWARE CONTENTS Note: Hardware not shown actual size.

PACKAGE CONTENTS

Anchor

Dry Wall Screw

Wire Connector

Plastic Plug

SAFETY INFORMATION

• All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).

Contact your municipal building department to learn about your local codes, permits and/or inspections.

• Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician

before installation.

Please read and understand this entire manual before attempting to assemble, operate or install the product.

WARNING

•

Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or switching

off circuit breaker).

• Be careful not to damage or cut the wire insulation (cove ring) during fixture installation. Do not permit wires to contact

any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury

or death from electric shock.

• LED electronics can be damaged by electro static discharge (ESD)shock. Before installation, discharge yourself by

touching a grounded bare metal surface to remove this hazard. To avoid damage, do not touch the LED module.

CAUTION

Sku Number: 348-2130

348-2131

LED WRAP LIGHT

Model Number: Z-TW0603B

Z-TW1203B

Summary of content (4 pages)

PAGE 1
Sku Number: 348-2130 348-2131 LED WRAP LIGHT Model Number: Z-TW0603B Z-TW1203B Questions, problems, missing parts? Before returning to your retailer, call our customer service at 1-855-508-3883 Monday – Friday 9:00 a.m. – 5:00 p.m. CST PACKAGE CONTENTS A C BB HARDWARE CONTENTS Note: Hardware not shown actual size.
PAGE 2
PREPARATION Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble, install or operate the product. Contact customer service for replacement parts. Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters, Safety Glasses, Ladder, Wire Stripper.
PAGE 3
ASSEMBLY INSTRUCTIONS (continued) 3 Outlet Box Source Wire Wire Connector (C) Fixture Wire 3. Pull out the source wires from the outlet box. Make wire connections using wire connectors as follows: ---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source. ---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
PAGE 4
CARE AND MAINTENANCE Caution: Before attempting to clean the fixture, disconnect the power to the fixture by turning the breaker off or removing the fuse from the fuse box. This LED light fixture is made from quality materials that will last many years with minimum care. You may want to periodically clean the fixture with a soft cloth. To maintain the best appearance of the fixture, do not use cleaners with chemicals, solvents or harsh abrasives.