Integration Instructions
Table Of Contents
Frequency 76-81 GHz coverage with 4-GHz bandwidth -
Transmit Power Up to 0.98 dBm EIRP
Vertical FOV 90 degrees -
Horizontal FOV 95 degrees -
Power Usage Less than 2 Watts Typical, active
Data Rate 50 KBps Typical, active
Max Reports 100 Maximum number of simultaneous, individual reports from sensor
Max Range 6 meters Max distance an object can be detected
Min Range 6 cm Closest distance an object can be detected
Resolution 4 cm Range measurement resolution
Applicable Rules
FCC ID: 2ASQO-P003110
This device complies with part 95 and part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Consult the dealer or an experienced radio/TV technician for help.
IC: 24864-P003110
This device complies with Industry Canada RSS 251 and RSS-GEN standards. Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the
device.
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS 251 et RSS-GEN. Son fonctionnement est soumis aux deux
conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et (2) cet appareil doit accepter toute interférence, y compris celles
pouvant causer un mauvais fonctionnement de l'appareil.
Operating Conditions
Description High Low
Operating Temperature 40 C -10 C
Storage Temperature 80 C -40 C
Water & Dust Not rated, dependent on enclosure
Physical Mounting & Packaging
Do Not Modify
Changes or modifications not expressly approved by Patroness may void your authority to operate the equipment.
ESD Protection
This module can be damaged by . PatronessESD recommends that all modules be handled with appropriate precautions. Failure to
observe proper handling and installation procedures can cause damage.
ESD damage can range from subtle performance degradation to complete device failure.
Antenna Care
Particular care should be taken to avoid scratching or damaging the antenna array.