Certifications 2

SDS No.: 390436 V005.0
Pattex Kraftkleber Classic
Page 9 of 21
Biological Exposure Indices:
None
8.2. Exposure controls:
Respiratory protection:
Suitable breathing mask when there is inadequate ventilation.
Combination filter: ABEKP (EN 14387)
This recommendation should be matched to local conditions.
Hand protection:
Recommended are gloves made from Nitril rubber ( Material thickness >0,1 mm, Perforation time < 30s).Gloves should be
replaced after each short time contact or contamination. Available at laboratory specialized trade or at pharmacies / chemist's
shops.
In the case of longer contact protective gloves made from nitrile rubber are recommended according to EN 374.
Perforation time > 10 minutes
material thickness > 0.4 mm
In the case of longer and repeated contact please note that in practice the penetration times may be considerably shorter than
those determined according to EN 374. The protective gloves must always be checked for their suitability for use at the specific
workplace (e.g. mechanical and thermal stress, product compatibility, antistatic effects, etc.). The gloves must be replaced
immediately at the first signs of wear and tear. The information provided by the manufacturers and given in the relevant trade
association regulations for industrial safety must always be observed. We recommend that a hand care plan is drawn up in
cooperation with a glove manufacturer and the trade association in accordance with the local operating conditions.
Eye protection:
Goggles which can be tightly sealed.
Protective eye equipment should conform to EN166.
Skin protection:
Suitable protective clothing
Protective clothing should conform to EN 14605 for liquid splashes or to EN 13982 for dusts.
Advices to personal protection equipment:
The information provided on personal protective equipment is for guidance purposes only. A full risk assessment should be
conducted prior to using this product to determine the appropriate personal protective equipment to suit local conditions.
Personal protective equipment should conform to the relevant EN standard.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Appearance
liquid
highly viscous
beige
Odor
Solvent
Odour threshold
No data available / Not applicable
pH
No data available / Not applicable
Melting point
No data available / Not applicable
Solidification temperature
No data available / Not applicable
Initial boiling point
75 °C (167 °F)
Flash point
< -10 °C (< 14 °F); DIN EN ISO 3679
Evaporation rate
No data available / Not applicable
Flammability
No data available / Not applicable
Explosive limits
lower
upper
1,4 %(V)
8,60 %(V)
Vapour pressure
(20 °C (68 °F))
120 mbar
Vapour pressure
(25 °C (77 °F))
150 mbar
Vapour pressure
(50 °C (122 °F))
430 mbar
Vapour pressure
(70 °C (158 °F))
860 mbar
Relative vapour density:
No data available / Not applicable