- Patton Electronics Long Range Ethernet Extender Quick Start Guide

ManualsBrandsPatton electronic ManualsNetwork Router07M2160-QS

CopperLink™ Model 2160 Series

Long Range Ethernet Extender

Quick Start Guide

Part Number: 07M2160-QS, Rev. A

Revised: December 14, 2009

Sales Ofﬁce: +1 (301) 975-1000

Technical Support: +1 (301) 975-1007

E-mail: support@patton.com

WWW: www.patton.com

Summary of content (8 pages)

PAGE 1
CopperLink™ Model 2160 Series Long Range Ethernet Extender Quick Start Guide Part Number: 07M2160-QS, Rev. A Revised: December 14, 2009 Sales Office: +1 (301) 975-1000 Technical Support: +1 (301) 975-1007 E-mail: support@patton.com WWW: www.patton.
PAGE 2
WARNING • The Model 2160 contains no user serviceable parts. The equipment shall be returned to Patton Electronics for repairs, or repaired by qualified service personnel. Opening the Model 2160 case will void the warranty. • Mains Voltage: Do not open the case the when the power cord is attached. Line voltages are present within the power supply when the power cords are connected.
PAGE 3
Printer WAP Notebook RAID Drive Server Desktop PC Switch Desktop PC Notebook DC 9V LAN MGMT CONSOLE LINE RST + - LAN Desktop PC Laptop computer Figure 1. Model 2160 Connection Diagram 2.0 Choose a configuration method and log in There are three methods to configure the Model 2160: serial console, Telnet and Web Browser. You must choose one method to configure the Model 2160. 2.
PAGE 4
2.2 Serial console configuration For configuring the Model 2160 through the serial console, connect a terminal or a PC equipped with a terminalemulation program (such as Hyper Terminal) to the Model 2160's console port. Use the supplied serial cable (RJ-45 to DB9F) to connect the Model 2160 to a PC. After marking the connection, configure the terminal-emulation program using the following parameters: 9600 bps , 8 data bits , no parity and 1 stop bit. 2.
PAGE 5
A.3 Industry Canada Notice This equipment meets the applicable Industry Canada Terminal Equipment Technical Specifications. This is confirmed by the registration number. The abbreviation, IC, before the registration number signifies that registration was performed based on a Declaration of Conformity indicating that Industry Canada technical specifications were met. It does not imply that Industry Canada approved the equipment.
PAGE 6
Copyright statement Copyright © 2009, Patton Electronics Company. All rights reserved. The information in this document is subject to change without notice. Patton Electronics assumes no liability for errors that may appear in this document. Trademarks statement The term CopperLink is a trademark of Patton Electronics Company. All other trademarks presented in this document are the property of their respective owners. Patton support headquarters in the USA • Online support: Available at www.patton.
PAGE 7
NOTES ____________________________________________________________________ ____________________________________________________________________ ____________________________________________________________________ ____________________________________________________________________ ____________________________________________________________________ ____________________________________________________________________ ____________________________________________________________________ _______________________
PAGE 8
NOTES ____________________________________________________________________ ____________________________________________________________________ ____________________________________________________________________ ____________________________________________________________________ ____________________________________________________________________ ____________________________________________________________________ ____________________________________________________________________ _______________________