- Patton VoIP SoHo Router Getting Started Guide

Settings 30
SmartLink 4020 Getting Started Guide 4 • Network—WAN
MAC address
The MAC address of the WAN Ethernet interface in the SmartLink.
Subnet Mask
The subnet mask is 32-bit number that filters a destination IP address to determine to which subnet it belongs.
For example, a subnet mask of 255.255.0.0 for a network ID of 192.5.0.0 tells the switch to accept traffic des-
tined for IP addresses that begin with 192.5—all other packets are ignored.
Default Gateway
The IP address of the gateway. The gateway IP address can be retrieved automatically in DHCP mode or be set
up manually with a fixed IP address.
Domain name
The network domain name of the SmartLink.
DNS address
Refers to the address of your domain name server that was defined under WAN settings or that was learned
dynamically through DHCP.
DynDNS address
The IP address of the dynamic DNS server that will be notified when the SmartLink 4020’s dynamic IP
address changes.
VLAN
VLAN tag value encoded in the WAN Ethernet header in all outgoing packets
Priority Tag
Priority tag value encoded in the WAN Ethernet header in outgoing packets.
Settings
The Settings window contains the following sections:
• Internet Configuration (see figure 6 on page 31)
• WAN PPPoE Configuration (see figure 7 on page 32)
• MAC Spoofing Configuration (see figure 9 on page 33)
• MTU (see figure 10 on page 34)
• Internet VLAN Configuration (see figure 9 on page 33)
Note After configuring the sections, click the Save Internet Settings button (see
figure 5 on page 29) to save the new configuration.