- Patton VoIP Gateway Router Quick Start Guide

SmartNode 4520 and 4110 Quick Start Guide 7
5.0 Download a configuration example, adapt it to your network,
and load it onto the SmartNode
Patton provides a collection of configuration templates on the CD-ROM shipped
with your SmartNode device—and also on the support page at
www.patton.com/voip/appnotes.shtml . In most cases, one of these tem-
plates should be similar to your application so that you can use it to speed up con-
figuring the SmartNode. Simply download to your PC the configuration note that
most closely matches your application. Adapt the configuration as described in
the configuration note to your network (remember to modify the IP address) and
copy the modified configuration to a TFTP server. The SmartNode can now load its
configuration from this server.
Note Patton regularly adds new configuration templates to the collection at
www.patton.com/voip/appnotes.shtml , so if you do not see your
application on the CD-ROM, it may have been added to the website. In addi-
tion, www.patton.com/voip/confignotes.shtml provides a library
of configuration templates for popular SmartNode services and features.
Note If your application is unique and not covered by any of Patton’s configura-
tion templates, you can manually configure the SmartNode instead of load-
ing a configuration file template. In that case, refer to the
SmartNode
Series SmartWare Software Configuration Guide for information on con-
figuring the SmartNode device.
In this example we assume an TFTP server resides on the host with the IP address
10.10.1.11 and the configuration file named SN.cfg resides in the root directory
of the TFTP server.
10.10.22.50(if-ip)[eth0]# copy tftp://10.10.1.11/SN.cfg startup-
config
Download...100%
10.10.22.50(if-ip)[eth0]#
After you reboot the SmartNode the new startup configuration will become active.
10.10.22.50(if-ip)[eth0]# reload
Running configuration has been changed.
Do you want to copy the 'running-config' to the 'startup-config'?
Press 'yes' to store, 'no' to drop changes : no
Press 'yes' to restart, 'no' to cancel : yes
The system is going down
When you issue the reload command, the SmartNode will ask
if you want to copy the running configuration to the startup
configuration. Since you just downloaded a configuration file
to the startup configuration you must answer this question with
NO . Otherwise, the downloaded configuration will be over-
written and lost!
IMPORTANT