- Patton Power Utility Heater Owner's Guide

ManualsBrandsPatton electronic ManualsFanPPH3185

PLEASE READ AND SAVE THESE

IMPORTANT SAFETY INSTRUCTIONS

FEATURES - OPERATIONS

CLEANING/MAINTENANCE

Thank you for purchasing this Patton

product. We

understand the value of quality and are committed to

making superior products that stand the test of time. We

trust this product will exceed your expectations of quality

and reliability. We hope that you enjoy this product and

will consider purchasing another Patton

product in the

future.

To see our full product line or if you have any questions

or comments about this product, please visit our website

at: www.pattonproducts.com.

When using electrical appliances, basic safety precautions

should always be followed to reduce the risk of fire,

electric shock, and injury to persons, including the

following:

1. Read all instructions before using the appliance.

2. To avoid fire or shock hazard, plug the appliance

directly into a 120V AC electrical outlet.

3. The heater is hot when in use. To avoid burns, DO

NOT let bare skin touch hot surfaces. If provided, use

handles when moving this heater. Keep combustible

materials, such as furniture, pillows, bedding, papers,

clothes, and curtains at least 3 ft (0.9 m) from the

front of the heater and keep them away from the

sides and rear.

4. DO NOT run cord under carpeting. DO NOT cover

cord with throw rugs, runners, or the like. Arrange

cord away from traffic area and where it will not be

tripped over.

5. This heater is not intended for use in bathrooms,

laundry areas and similar indoor location. NEVER

locate heater where it may fall into a bathtub or

other water container.

6. Extreme caution is necessary when any heater is

used by, or near children or invalids, and whenever

the heater is left operating and unattended.

7. Always unplug the heater when not in use.

8. When unplugging, be sure to pull by the plug and

not the cord.

9. DO NOT insert or allow foreign objects to enter any

ventilation or exhaust opening as this may cause an

electric shock or fire, or damage the heater.

10. DO NOT operate heater with a damaged cord or

plug, or after the heater malfunctions, has been

dropped or damaged in any manner. Return

appliance to manufacturer for examination, electrical

or mechanical adjustment, or repair.

11. A heater has hot and arcing or sparking parts inside.

DO NOT use it in areas where gasoline, paint, or

flammable liquids are used or stored.

12. Use appliance only for intended household use as

described in this manual. Any other use not

recommended by the manufacturer may cause fire,

electric shock, or injury to persons. The use of

attachments not recommended or sold by the

manufactuer may cause hazards.

13. DO NOT use outdoors.

14. To prevent a possible fire, DO NOT block air intakes or

exhaust in any manner. DO NOT use on soft surfaces,

like a bed, where openings may become blocked.

15. To disconnect heater, turn controls to OFF, then

remove plug from outlet.

16. Avoid the use of an extension cord because the

extension cord may overheat and cause a risk of fire.

However, if you have to use an extension cord, the

cord shall be No. 14 AWG minimum size and rated

not less than 1875 watts.

17. If the heater will not operate, see specific instructions

on Auto Safety Shut-off.

18. DO NOT attempt to repair or adjust any electrical or

mechanical functions on this unit. Doing so will void

your warranty. The inside of the unit contains no user

serviceable parts. All servicing should be performed

by qualified personnel only.

19. Discontinue use if plug or outlet is hot. It is

recommended that the outlet be replaced if plug or

outlet is hot to touch.

PLEASE READ AND SAVE

THESE IMPORTANT SAFETY

INSTRUCTIONS

TECHNICAL SPECIFICATIONS

• Wattage: 1500 W (+5% –15%)

• Working Voltage: 120V AC/60Hz

AUTO SAFETY SHUT-OFF WITH CERAMIC

CONTROL

This heater is equipped with a patented, technologically-

advanced safety system that requires the user to reset

the heater if there is a potential overheat situation.

When a potential overheat temperature is reached, the

system will automatically shut the heater off. It can only

resume operation when the user resets the unit. For

specific instructions please refer to the unit.

Reset Instructions:

If the unit shuts down:

1. Turn MODE to OFF (

) and THERMOSTAT to HI (

•

2. Unplug unit, wait 10 minutes.

3. Plug in and turn ON.

Tip-Over Shut-Off:

When the unit is accidentally knocked over, it will

instantly shut off. To reset, simply place the heater in an

upright position on a level surface.

PRE-OPERATING INSTRUCTIONS

1. Carefully remove your heater from the box. Please

save the carton for off-season storage.

2. Make sure the unit is in the OFF position before

plugging the heater into the outlet.

3. Place heater on firm level surface.

4. Avoid overloading your circuit by not using other

high wattage appliances in the same outlet. At 1500

Watts, this unit draws 12.5 Amps.

OPERATING INSTRUCTIONS

1. For heater operation, please set the Thermostat all

the way to HI (

•

). (See Fig. 1)

2. Turn the Mode Control to desired heat setting LO (I)

or HI (II).

3. For fan-only operation, without any heat output, turn

the Mode Control to the FAN ( ) setting.

4. The Power Light will remain lit during operation.

SETTING THE THERMOSTAT

1. You need to set thermostat on HI to start heater (See

Fig. 1). Allow heater to operate and warm up the

room.

2. When the desired temperature/comfort level is

reached, lower the thermostat setting until the heater

stops operating.

3. The control will now automatically maintain the pre-

set temperature level by turning the heater ON and

OFF.

Note: It is normal for the heater to cycle ON and OFF as

it maintains the preset temperature. To prevent the unit

from cycling, you need to raise the thermostat setting.

ANTI-FREEZE SETTING

This special setting will automatically turn on the heater

if the room's temperature reaches freezing. To set, turn

the Thermostat Control all the way to LO (

•

), and turn

Mode Control to either HI (II) or LO (I).

CLEANING/MAINTENANCE

During Season Care:

1. Always unplug the heater before cleaning.

2. Clean the unit with a soft cloth moistened with a mild

soap solution.

3. NEVER use abrasive or flammable solvents to clean

the unit.

4. After cleaning, be sure to completely dry the unit

with a cloth or towel.

After Season Care:

1. Store heater in a cool, dry location.

2. The manufacturer recommends that you store the

unit in its original carton.

TROUBLESHOOTING

If your heater fails to operate:

• UNPLUG THE UNIT.

• Make sure the electrical outlet or circuit breaker is

working.

• Check for obstructions. If you find an obstruction turn

the heater OFF, and unplug the unit. Carefully

remove the obstruction and follow the reset

instructions.

• The temperature may be set too low. Turn the

thermostat knob clockwise until the heater restarts.

• Make sure selector is in LO (I) or HI (II) setting.

Please DO NOT attempt to open or repair the heater.

Please see the Warranty for Service Instructions

or call consumer service at 1-800-546-5637.

THIS APPLIANCE HAS A POLARIZED PLUG (one blade is wider than the

other). To reduce the risk of electric shock, this plug is intended to fit in

a polarized outlet only one way. If the plug does not fit fully in the

outlet, reverse the plug. If it still does not fit, contact a qualified

electrician to install the proper outlet.

DO NOT ATTEMPT TO MODIFY THIS PLUG OR DEFEAT THIS

SAFETY FEATURE IN ANY WAY.

Fig. 1

A. Power Light

B. Thermostat Control

C. Carry Grip (not

shown)

D. Selector Mode

Control

E. Large Stable Base

PPH3185-U_07EM1.qxd 4/9/07 14:16 Page 2