User Guide

Localization 61
SmartLink M-ATA Getting Started Guide 6 • System
Voicemail access
Configures the key sequence for call for voicemail access. The factory default is flash hook *86. If the voicemail
key sequence is entered on the phone a call will automatically be placed to the configured service provider
using the configured authentication information.
Call Forward Busy Destination
Configures the number to forward calls to when busy. To configure call forward busy enter the calling prefix
key (*74 is the factory default), the number to dial and then on hook the phone. You will hear a second dial
tone after entering the calling prefix key. Before using, call forward busy must be enabled using the activate
sequence defined in the supplementary service table.
Example:
*743019751000 and on-hook the phone. All calls received will forward to 3019751000 when the phone
is busy.
Hotline
Configures the number to call when the telephone goes off hook. To configure the hotline number enter the
calling prefix key (*75 is the factory default), the number to dial and then on hook the phone. You will hear a
second dial tone after entering the calling prefix key. Before using hotline calling it must be enabled using the
activate sequence defined in the supplementary service table.
Example:
*753019751000 and on-hook the phone. When the handset is lifted, 3019751000 will immediately be called.
Control Timer Values
Figure 36. Control Timer Values section of Localization window
Hook Flash Timer
Maximum on-hook time before off-hook to qualify as hookflash. More than this value and the on-hook event
is treated as on-hook (hanging up the call).
Minimum on-hook time before off-hook to qualify as hookflash. At less than this value, the on-hook event
is ignored.
SIP Session Timer value
The amount of time the SmartLink M-ATA will wait during an active call to send repeated re-invites on active
calls to allow the SIP server to determine the status of a call.