- Patton Electronics IpChannel Bank Getting Started Guide

Introduction 24

SmartNode 4400 Series Getting Started Guide 3 • Hardware installation

Introduction

This chapter contains information for planning the installation of the SmartNode 4400 IpChannel Bank with

the following installation procedures:

• Section “Unpacking the Model SN4400 series IpChannel Bank” on page 27 lists the contents of the ship-

ping box

• Section “IpChannel Bank chassis installation” on page 27 describes installing the IpChannel Bank on a ﬂat

surface or in a 19-inch rack

• Section “Connecting cables” on page 28 describes installing the power and port cables

• Section “Connecting power” on page 30 describes how to verify that the IpChannel Bank is ready for con-

ﬁguration

Planning the installation

Before beginning the actual installation, we strongly recommend that you gather all the information you will

need to install and set up the device. See table 4 for an example of installment checklist that may be necessary

for a smoother installation. Completing the pre-installation checks enables you to install and set up your

IpChannel Bank within an existing network infrastructure with conﬁdence.

Before installing the IpChannel Bank device, the following tasks should be completed:

• Prepare an installation checklist using the list provided in section “Installation checklist” on page 25

• Initiate and mantain a site log using the information in section “Site log” on page 25 as a guide

• Create a network diagram (see section “Network information” on page 26)

• Gather IP related information (see section “IP related information” on page 26 for more information)

• Install the hardware and software needed to conﬁgure the SmartNode. (See section “Conﬁguration tools”

on page 26)

• Verify power source reliability (see section “Power source” on page 27).

When you ﬁnish preparing for your VoIP installation, go to section “Installing the IpChannel Bank” on

page 27 to install the device.