User Manual

Rev. H 1210
44527 pg 3
Front
5/16" Phillips Bolt
Sport Bar
Side Belt
Rail
Step Two
INSTALL BELT RAILS
Install the Left and Right Side Belt
Rails on each side of the vehicle.
Use the existing holes, three 5/16"-
18 x 1 Phillips Bolts and three
5/16"-18 Tapping Plates on each
side.
5/16" Phil-
lips Bolt
Tapping Plate
Side Belt Rail
Body Panel
Inside of Vehicle
Side Belt Rail Detail
Cross Section
Sport Bar
Step One
INSTALL WINDSHIELD BRACKETS
Loosen the top screw on the A Pillar Molding. Use a #40 TORX
Driver to remove the outboard bolt that attaches the Sport Bar
to the windshield. Slide the Windshield Bracket behind the A
Pillar Molding and reinstall the bolt you removed to secure the
bracket to the windshield. Re-tighten the top molding screw.
Tools Needed
1/8" Drill Bit Flat Screwdriver
and Drill Motor Phillips Screwdriver
Center Punch Hammer
#35 Torx Pencil
#40 Torx Adjustable Wrench
Ratchet Safety Glasses
Windshield
Bracket
#40 TORX
A Pillar Molding
Windshield
Top Molding
Screw
Sport Bar
Safety glasses should be worn at all
times while installing this product.
Caution