User Manual

Rev. H 1210

44527 pg 5

Step Four

ASSMEBLE BOW ASSEMBLY

Assemble the two halves of the support bow. Orient the two pieces to each other and lay them on the ﬂ oor. Slide the pieces to-

gether, pushing down on the buttons. Once the two halves are together install a Snap Head Screw in the hole formed in the center,

front of each bow. This will require a #20 TORX socket.

Front Bow

Rear Bow

Foam

Slide Bow

Halves Together

Push buttons in

Slide halves together to form

Support Bow Assembly

Note: It may be helpful to use a ﬂ at screwdriver to push buttons down while sliding bow halves together.

Slide Bow Ends

into Track

Front Bow

Rear Bow

Inside of Vehicle

Side Belt Rail

Note: It may be helpful to have two people to slide both sides of the

bow assembly forward at the same time.

Step Five

INSTALL BOW ASSEMBLY

Slide the ends of the front and rear bows into the tracks in the Side

Belt Rails on each side of the vehicle. Start from the rear of the vehicle

and slide the bow assembly toward the front.