Owner's manual

44587 pg 3
Rev. H 1210
Front
5/16" TORX Bolt
Sport Bar
Side Belt
Rail
Step Two
INSTALL BELT RAILS
Install the Left and Right Side Belt Rails
on each side of the vehicle. Use the
existing holes, three 5/16"-18 x 1 TORX
Bolts and three 5/16"-18 Tapping Plates
on each side. Use a #35 TORX Socket to
install the TORX Bolts.
5/16" TORX
Bolt
Tapping Plate
Side Belt Rail
Body Panel
Inside of Vehicle
Side Belt Rail Detail
Cross Section
Sport Bar
Step One
INSTALL WINDSHIELD BRACKETS
Loosen the Top Molding Screw on the A Pillar Molding at-
tached to each side of the windshield. With a #40 Torx Driv-
er, remove the outboard bolt that attaches the Sport Bar to
the Windshield. Slide the Windshield Bracket behind the A
Pillar Molding and fasten the bracket to the Windshield with
the bolt you removed. Re-tighten the top Molding screw.
Tools Needed
1/8" Drill Bit Flat Screwdriver
and Drill Motor Phillips Screwdriver
Center Punch Hammer
#35 Torx Pencil
#40 Torx Adjustable Wrench
Ratchet Safety Glasses
Windshield
Bracket
#40 TORX
A Pillar Molding
Windshield
Top Molding
Screw
Sport Bar
Safety glasses should be worn at all
times while installing this product.
Caution