OWNER’S MANUAL 6V PAW PATROL QUAD this manual contains important safety, performance and maintenance information. read the manual before taking your first ride or allowing your child to ride your new electric ride- on toy. keep the manual handy for future reference. DO NOT RETURN THIS ITEM TO THE STORE CONTACT DYNACRAFT CUSTOMER SERVICE FOR ASSISTANCE dynacraftwheels.
TABLE OF CONTENTS A Introduction, Safety and Warnings. . . . . . . . . . . . . . . . 2 B Before You Begin Assembly. . . . . . . . . . . . . . . . . . . . 6 C Parts Diagram. . . . . . . . . . . . . . . . . . . . . . . . . . 7 D Assembly. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 E How to Use Your Ride-On Toy. . . . . . . . . . . . . . . . . . 12 F Detailed Maintenance and Repair . . . . .
INTRODUCTION, SAFETY AND WARNINGS A ABOUT THIS MANUAL: This Manual was written to help you and your child get the most performance, comfort, enjoyment and safety when riding your new electric ride-on toy. It is important for you to understand your new electric ride-on toy. By reading this manual before you let your child go out on his/her first ride, you will know how to get the most from your new electric ride-on toy.
RIDER USE AND REQUIRED PARENTAL SUPERVISION RIDERS MUST NOT EXCEED THE WEIGHT LIMIT OF 40 lb (18 kg) and MUST BE OVER 18 MONTHS OLD. The age grade for the electric ride-on toy is for ages 18-36 months. Just because your child is within the age and weight limitations specified for the electric rideon toy, does not mean that his/her size is appropriate to fit or maintain control of the electric ride-on toy, or that he/she is capable of safely operating the electric ride-on toy.
SAFE RIDING PRACTICES AND WARNINGS • Check and obey all local laws or regulations which may be in effect in the locations where the electric ride-on toy may be used. • Always wear appropriate clothing and shoes. • Observe the age and weight limitations on the cover of this manual. • Always stay seated while riding the electric ride-on toy. To stop you must take your foot off the foot pedal. • Children must be supervised by an adult at all times to be safe.
• Do not to allow hands, feet, hair, body parts, clothing, or similar articles to come in contact with wheels or other moving parts.
BEFORE YOU BEGIN ASSEMBLY WARNING: DO NOT USE NON-ORIGINAL OR NON-RECOMMENDED PRODUCTS WITH YOUR ELECTRIC RIDE-ON TOY. Altering of the original components or use of non-recommended replacement parts may or may not be compatible with the design and will void the warranty and may cause an unsafe condition resulting in serious injury or death. If you experience a problem with this product, or are missing a part, please call us at 1-800-551-0032, rather than return this product to the store.
PARTS DIAGRAM C Tools Required Screwdriver (not included) 1 2 3 4 5 7 6 1. 2 3. 4. 5. 6. 7.
ASSEMBLY D Your new ride-on toy has been assembled at the factory, but you will need to connect the power supply. TOOLS REQUIRED: Phillips Screwdriver (not included) WARNING: Children can be harmed by small parts, sharp edges and sharp points in the ride-on toy's unassembled state, or by electrical items. In the unassembled state, this package contains small parts. Adult assembly is required; children should not handle parts, or help in assembly of the ride-on toy. 1.
2. CHARGER LOCATION NOTE: Charger is located in seat compartment. Battery Cover Charger Charger Located in Seat Compartment BATTERY CHARGING IMPORTANT! Before first time use, charge the battery for at least 18 hours. Charge the battery for at least 12 hours after each use of the ride-on toy. Never charge the battery longer than 30 hours. Overcharging or undercharging the battery may shorten battery life and decrease ride-on toy running time.
PREVENT FIRE • Never modify the electrical system. • Alterations could cause a fire resulting in serious injury and could also ruin the electrical system. • Use of the wrong type battery or charger could cause a fire or explosion, resulting in serious injury. • Use of non-original components on this ride-on toy could cause overheating, fire or explosion. • The battery must be handled by adults only. • The battery is heavy and contains sulfuric acid (electrolyte).
• Do not allow the battery to run down completely before charging. • Charge the battery before storing the ride-on toy. • Charge the battery at least once per month, even if the ride-on toy has not been used. NOTE: • This product has CHARGING PROTECTION: when charging, all the functions will be cut off. • Recharges after initial charge - Up to 12 hours, and never charge the battery longer than 30 hours. • When the ride-on toy begins to run slowly, recharge the battery.
HOW TO USE YOUR RIDE-ON TOY E Sound Button Foot Pedal FOOT PEDAL To move the ride-on toy, press the foot pedal down. To stop, take your foot off the foot pedal. SOUND BUTTON Press the sound buttons on the steering wheel to play sounds.
IMPORTANT • Do not let any child touch the wheels or be near them when the ride-on toy is moving. • To avoid accidents, please inspect the ride-on toy before riding to ensure that it is in proper working order and safe to ride. • This toy has no brake; to stop, take your foot off the foot pedal. • Check all the screws, cap nuts and protective coverings regularly and tighten as required. Check plastic parts on a regular basis for cracks or broken pieces.
DETAILED MAINTENANCE AND REPAIR NOTE: Disconnect the power connector from the battery connector before conducting any maintenance procedures. TOOLS REQUIRED: Phillips Screwdriver (not included) Flat Head Screwdriver (not included) HOW TO REPLACE THE BATTERY Power Connector 2 1 3 Battery Connector Battery Cover Battery 1. Unscrew the screw on the seat with a screwdriver and remove the seat. 2. Use a screwdriver to remove the 4 screws from the battery cover. 3.
HOW TO REPLACE THE FOOT PEDAL Pedal Switch Cover 1 Pedal Switch Wire Terminal 2 3 4 Pedal Switch Socket 1. Disconnect the power connector from the battery connector as shown in the diagram on page 8. 2. Gently turn the ride-on toy on the side, unscrew two screws from foot pedal cover and disconnect the two wire terminals from the pedal switch as shown (see Figure 1). 3. Hand squeeze the tabs under two sides of the pedal switch and push out to release the foot pedal. 4.
BATTERY CARE AND DISPOSAL Do not store the battery in temperatures above 75° F (23.5° C) or below 32° F (0°C). THIS PRODUCT CONTAINS SEALED LEAD ACID BATTERIES WHICH MUST BE RECYCLED IN ACCORDANCE TO YOUR LOCAL AND STATE LAWS. PLEASE CAREFULLY READ AND UNDERSTAND THE FOLLOWING DISPOSAL INSTRUCTIONS: DISPOSAL: This product contains sealed lead acid batteries which must be disposed of or recycled in an environmentally safe manner. Do not dispose of the batteries in your household trash.
MAINTAINING YOUR RIDE-ON TOY Occasionally use a lightweight oil to lubricate moving parts such as wheels and the steering linkages. Park the ride-on toy indoors or cover it with a tarp to protect it from wet weather. Keep the ride-on toy away from sources of heat, such as stoves and heaters. Plastic parts may melt. ADULTS ONLY: Recharge the battery after each use. Recharge the battery at least once a month when the ride-on toy is not being used. DO NOT wash the ride-on toy with a hose.
TROUBLESHOOTING GUIDE Problem Possible Cause Solution Ride-on toy does not run Undercharged battery Charge the battery. A new battery should have been charged for at least 18 hours before using the ride-on toy for the first time. After first-time use, recharge the battery for at least 12 hours after each use. Never charge the battery longer than 30 hours. Check all connectors.
Problem Possible Cause Solution Ride-on toy was running but suddenly stopped Loose wires or connectors Check all wires and connectors. Make sure the battery connector is tightly plugged into the power connector, and that there are no loose wires around the motor. Tripped fuse The fuse may “trip” and shut down operation of the ride-on toy if the ride-on toy is overloaded or the driving conditions too severe.
Problem Possible Cause Solution Ride-on toy runs sluggishly Undercharged battery Charge the battery. A new battery should have been charged for at least 18 hours before using the ride-on toy for the first time. After first-time use, recharge the battery for at least 12 hours after each use. Never charge the battery longer than 30 hours. Check all connectors. Make sure the battery connector is tightly plugged into the power connector, and that the charger is plugged into the wall outlet.
Problem Possible Cause Solution Charger gets warm during use It is normal for some chargers to get warm during use and is not reason for concern No action required. If your charger does not get warm during use, it does not mean that it is not working properly. Some chargers do not get warm during use Battery makes a sizzling or gurgling noise when charging 21 It is normal for some batteries to make noise and swell slightly while charging and is not reason for concern No action required.
LIMITED WARRANTY This Limited Warranty (“Warranty”) extends only to the original retail purchaser, who must provide proof of purchase to validate any claim. This Warranty is not transferrable to anyone else and is the only warranty for your Dynacraft product, to the extent permitted by law. No other express or implied warranty is given. Part or model specifications are subject to change without notice.
DO NOT RETURN THIS ITEM TO THE STORE CONTACT DYNACRAFT CUSTOMER SERVICE FOR ASSISTANCE dynacraftwheels.com/contact or 1-800-551-0032 8 AM – 5 PM ET Please have the following information available: Model Number Example: 8000-00 Production Date Example: MM.DD.YYYY Serial Number Example: DA00000000000 This information is required to help us handle your request effectively. Dynacraft BSC, Inc.
