6-MEAL AUTOMATIC PET FEEDER USER GUIDE PAW6MLWF
6-MEAL AUTOMATIC PET FEEDER USER GUIDE PAW6MLWF Thank you for purchasing the Pawple™ 6-Meal Automatic Pet Feeder. This User Guide is intended to provide you with guidelines to ensure that operation of this product is safe and does not pose risk to the user. Any use that does not conform to the guidelines described in this User Guide may void the limited warranty. Please read all directions before using the product and retain this guide for reference. This product is intended for household use only.
Product Overview 1 1. Display cover & carrying handle 2. Rotating lid 3. Release knob 2 4. LCD display screen 5. Storage tray 3 Control Panel: (See below) 6. On/Off button 7. Enter button 8. Up arrow button 4 9. Down arrow button 10. Start button 11. Speaker 12. Battery compartment A 13.
Get Started with your New Automatic Feeder Install Batteries 1. Turn the green knob on the lid from the lock ( ) to the unlock ( ) position to release it. 2. Remove the lid and flip it upside down. You will see two separate compartments, one large and one small. 3. Open both battery lids by pressing in the latches and pulling straight up. Fit the batteries into their designated spaces in the compartments. 4. Close the battery compartment covers and make sure the latches snap securely into place. 5.
Turn on the Feeder & Set the Time 1. Lift the green cover on the control panel and press the power button. If you have trouble with the display cover, try pressing the slightly raised green square on the cutout around the display panel and lifting up. 2. When the device is switched on, the time will automatically begin to flash 12:00 AM. This will happen every time the device is powered off and back on. 3. Press the ENTER button once to set the current time.
Setting Meal Sizes 6. For each meal, you can choose whether the feeder should open a single compartment or multiple compartments. This is indicated by the word BOX on the right side of the LCD display screen. Use the up and down arrows to cycle between one (1), two (2), or three (3) compartments to be opened. Press ENTER to confirm. 7. Repeat steps 2-6 until you have programmed times and sizes for all the meals you want to be scheduled.
5. If the LED light is flashing slowly, but the SERVED counter has not reached 6, this indicates that the batteries need to be changed. After changing the batteries (refer back to “Install Batteries” on page 3), you will need to turn the device back on and set the time. You will not need to reprogram the scheduled meals; those are stored in the feeder’s memory and those settings will not change unless you change them. 6.
Care and Maintenance • The feeder compartment is dishwasher-safe for your convenience. • The lid of the feeder is not dishwasher-safe. Do not submerge the lid in water; this could damage the internal electronics and cause the batteries to short out, create an electrical shock, or catch fire. To clean the lid, wipe it with a soft cloth and a mild cleaning agent. • Make sure all parts of the feeder are completely dry before refilling and re-assembling the device.
