Q80 Countertop Payment Terminal PAX TECHNOLOGY LIMITED
1. Product Description： 2. Installation 1） SAM Card Installation ① Open up battery cover, which is at the bottom of the terminal; ② Take out battery; ③ Insert SAM card to corresponding SAM card slot.
① Open up battery cover, which is at the bottom of the terminal; ② Take out battery; ③ Insert SD card to corresponding SD card slot. 3） Battery Installation ① Hold the battery with its sticker facing up; ② Attach battery forelock to battery bayonet; ③ Press down the other side of the battery 3. Instruction 1） Power ON/OFF Power on: Plug adapter,Press “CANCEL” button for 3 seconds until LED backlight is on, if POS terminal is being turned on successfully.
1 LAN port 1 Phone port 1 Line port 1 Pinpad port Printer : Thermal printer; Speed: 30 lines/sec; Paper width:58mm Paper roll outside diameter:40mm Power Supply：Input：100—240VAC ，0.6A 50/60HZ Output：9.0V DC1A Battery：Li-ion bttery,720mAh,7.4V Working Environment： Temperature：0 ℃~50℃(32℉~122℉) R.H.: 10%~93%(non-condense) Storage Environment： Temperature:-20℃ ~ 70℃ (-4℉~158℉) R.H.:5% ~95%(non-condense) Dimensions：L181*W83.5*H72 Weight：440g 5.
FCC Regulations: This device complies with part 15 of theFCC Rules. Operation is subject to the following two conditions: (1) This device maynot cause harmful interference, and (2) thisdevice must accept any interference received, including interference that maycause undesired operation. This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Grant section of www.fcc.gov/oet/ea/fccid after searching on FCC ID: V5PQ80 For this device, the highest reported SAR value for near the body is <0.10W/kg. While there may be differences between the SAR levels of various devices and at various positions, they all meet the government requirement. The REN is used to determine the quantity of devices which may be connected to the telephone line. Excessive REN’s on the telephone line may result in the devices not ringing in response to an incoming call.
