A30 Smart Payment Terminal
1.Contents Checklist Please check the components after unpacking. If any one of them is missing, or if there is a page missing from the product manual, etc., please contact the dealer. Part Qty. A30 Smart Payment Terminal 1 Product Manual 1 USB Cable 1 AC Power Adaptor 1 2.
.Installation 1）SAM/Micro-SD Card Installation 1) Unscrew the screw of the cover. 2) Push the cover to the right. 3) Insert SAM /micro-SD card into the card slot. 4) Install the cover.
2) Stand Installation Insert metal stand prongs into three stand slots on underside of terminal. Slide terminal firmly into place on stand.
4.Instruction 1) Power ON/OFF Power on: The device starts up automatically when it is electrified. Power off: Press power button for 3 seconds until Shutting down... can be seen. POS terminal is being turned off. 2) IC card Insert the IC card with the chip side faces up into the IC card slot and push it to the end.
3) Swiping contactless card Place a contactless card close to the induction zone which is at the back of the terminal.
4）Magnetic Stripe Card Swipe the magnetic stripe card through the magnetic card slot with the magnetic stripe faces you at a constant speed, which could be bi-directionally. 5. Installation and Usage Tips 1) Avoid exposing the terminal to direct sunlight, or hot / humid / dusty environment. 2) Forbid non-professionals to repair the terminal. 3) Before inserting card, please check the inside and periphery of the IC card slot. If there is any suspicious object, please report to the related administrator.
Class II Equipment For indoor use only Energy Efficiency Marking AC voltage DC voltage The MAINS plug is used as the disconnected device. The full text of the EU declaration of conformity is available at the following internet address: http://www.pax.com.cn/ProductCE.aspx FCC Regulations: This device complies with part 15 of the FCC Rules.
This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government. This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm (8 inches) during normal operation.
PAX TECHNOLOGY LIMITED reserves the right to change product technology specifications without notifying. PAX TECHNOLOGY LIMITED Manufacturer: PAX Computer Technology (Shenzhen) Co.,Ltd. Address:4/F, No.3 Building, Software Park, Second Central Science-Tech Road, High-Tech Industrial Park, Shenzhen, Guangdong, P.R.C. Tel: 0755-86169630 Fax: 0755-86169634 Website: http://www.pax.com.cn Responsible Party: PAX Technology, Inc.
