Quick Setup Guide

USB B-HOST output: 5V 500mA
USB C-HOST output: 5V 500mA
USB D-HOST output: 5V 500mA
Open the back cover to access following ports:
SD Card Slot Open card cover, remove battery and insert card into SD card slot
SIM Card Slot Open card cover, remove battery and insert SIM card into SIM slot to
connect to cellular carrier’s network.
4. Power ON/OFF
Power on: Press and hold the Power button for three seconds until the main screen displays
normally. (See page 1 for the location of the Power button.
Power off: Press and hold the Power button for three seconds until the shut down menu
displays. Select Power off. The terminal turns off after a few seconds. (See page 1 for the
location of the Power button.)
5. Hybrid Card Reader
The Q20 on the consumer-facing side of the E700 includes a reader that can be used as a Magnetic
Stripe, EMV, and NFC/Contactless card reader.
Magnetic Stripe Reader
Insert the card into the reader slot located on the top of the Q20. The terminal reads the
information from the card when the magnetic stripe is inserted into the card slot.
EMV Card Reader
Insert the card with the front facing you and the chip down into the card slot. Leave the card
inserted until the terminal prompts to remove the card.
NFC/Contactless Card Reader
Tap the card to the Q20 screen when prompted. The terminal uses an antenna device that
detects and retrieves information from the card.
6. Specifications