Quick Setup Guide

Icon shows
 The mains plug is used as the disconnect device, The socket-outlet shall be installed near the
equipment and shall be easily accessible.
 This product bears the selective sorting symbol for Waste electrical and electronic
equipment (WEEE). This means that this product must be handled pursuant to European
directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on the
environment. User has the choice to give his product to a competent recycling organization or
to the retailer when he buys a new electrical or electronic equipment.
 Moving parts Keep body parts away from moving parts.
Warning
To avoid replacement of a battery with an incorrect type
Don't disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a Battery.
Don’t leaving a battery in an extremely high temperature surrounding environment.
To avoid battery subjected to extremely low air pressure.
The marking information is located at the bottom of apparatus.
FCC Regulations:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one of the
following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
 Any changes or modifications not expressly approved by the party responsible for