Quick Setup Guide

ManualsBrandsPAX ManualsPOS EquipmentPOS Terminal

Table Of Contents

Note: Product images shown may be different than actual

product received.

Cable connectors at the other end of the cable provide an interface

to other systems for communications, to allow local downloading

and to provide power. Additionally some cables allow connecting

peripherals such as check readers and printers. All of the cable

connectors are labeled and color-coded, as follows:

• DC Power - Connects AC power adapter to the Q30

• RS232A (Blue, RJ11 6P4C), RS232B (Yellow, RJ11 6P4C), or

RS232 on C302 hub cable (RJ11 6P6C) - Connects an external

POS device or check reader

• RS232 (Black, DB9-F) – Used to connect to POS terminal

• USB-Host (Type A) or Micro USB 2.0 - Used for local terminal

downloads or external peripherals

• LAN (Red, Ethernet, RJ45-F) - Used for bi-directional Ethernet

connections, TMS, and/or payment processing

• Powered USB - to connect to POS/ECR systems

Quick Setup Guide

PAX™ Q30 Payment Terminal

Box Contents

Communication cable

(cable type varies by configuration)

AC power adapter

(included in some configurations)

• 1 - PAX™ Q30 payment terminal

• 1 - Communication cable (varies by configuration)

• 1 - AC power adapter (not included with PUSB configurations)

• 1 - Privacy shield

• 1 - Quick Setup Guide

Product Description

Stylus pen

Contactless reader

Camera

Touch screen

Speaker(inside)

Magnetic

stripe reader

Privacy shield

Keypad

Smart card reader

Back cover

MAC label

Regulatory label

Part number/

serial number label

Screw

Screw(under rubber foot)

Reset button

Audio jack

Cable Connectors

2x7P connector

The 2x7P connector end of the

provided communication cable

connects to the underside of the Q30.

A combination of the following ports are available on the

communication cable (depending on the Q30 configuration):

Privacy shield

Note: Stylus pen is an optional configuration for the terminal, it

may be not support on actual product received.

P/N:200312000000402

Summary of content (4 pages)

PAGE 1
Quick Setup Guide P/N:200312000000402 Product Description Box Contents Cable Connectors 3 PAX™ Q30 Payment Terminal Screw The 2x7P connector end of the provided communication cable connects to the underside of the Q30.
PAGE 2
Attach 2x7P Connector 4 8 6 To connect 2x7P end of cable: 1. Loosen the screw on the underside of the Q30 using a Philips head screwdriver. 2. Open the back cover. 3. Place the 2x7P end of the provided communication cable over its port, but do not push into place. 4. Align rubber sliding pull restraint so that it seats into its notch on the Q30. 5. Firmly press the 2x7P end of the cable into the port. 6. Close the back cover and tighten the screw, ensuring the gasket is properly seated in the opening.
PAGE 3
FCC Statement 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
PAGE 4
accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.