Product Manual
Table Of Contents
- X3s Wireless Data Terminal
- Contents Checklist
- Product Description
- Installation
- 1. Unlock and Lock the Rear Cover
- 2. Install and Remove the Battery
- 3. Install SIM Card/PSAM Card /TF Card
- 4 Device Charging
- 5 Installation Diagram of Wrist Strap
- Instructions
- 1. Use of Two-dimensional Scanner (One-dimensional Optional)
- 2. Use of Contactless Card
- 3. PSAM Card
- Precautions for Installation and Use
- Precautions for Lithium Battery Usage
- /
- PAX TECHNOLOGY LIMITED
- Manufacturer: PAX Computer Technology (Shenzhen) Co.,Ltd.
- Address:4/F, No.3 Building, Software Park, Second Central Science-Tech Road, High-Tech Industrial Park, Shenzhen, Guangdong, P.R.C.
- Tel: 0755-86169630 Fax: 0755-86169634
- Website: http://www.pax.com.cn
- Responsible Party: PAX Technology, Inc.
- 8880 Freedom Crossing Trail, Building 400, 3rd Floor Suite 300, Jacksonville , Florida, 32256
the device is designed to operate at multiple power levels so as to use only the power
required to reach the network. In general, the closer you are to a wireless base station
antenna, the lower the power output.
The exposure standard for wireless employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg.
The FCC has granted an Equipment Authorization for this model device with all reported
SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR
information on this model device is on file with the FCC and can be found under the
Display Grant section of
www.fcc.gov/oet/ea/fccid after searching on
FCC ID: V5PX3S
For this device, the highest reported SAR value for usage near the body is
1.26
W/kg.
While there may be differences between the SAR levels of various devices and at various
positions, they all meet the government requirement.
ISED Notice
This device complies with Innovation, Science and Economic Development Canada
license-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présentappareilestconforme aux CNR Innovation, Sciences
etDéveloppementéconomique Canada applicables aux appareils radio exempts de
licence. L'exploitationestautorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareildoit accepter tout brouillageradioélectriquesubi, mêmesi le
brouillageest susceptible d'en
IC: 11689A-
X3S
ISED Radiation Exposure Statement
This EUT is in compliance with SAR for general population/uncontrolled exposure limits in
ISED RSS-102 and had been tested in accordance with the measurement methods and
procedures specified in IEEE 1528 and IEC 62209. This device and its antenna(s) must
not be co-located or operating in conjunction with any other antenna or transmitter.