Monarch Sierra Sport 3R 9430R Printer Quick Reference Guide

ManualsBrandsPaxar ManualsPrinter3R 9430R

Tab

QUICK REFERENCE

Use this

Quick Reference

along with your Paxar Monarch Sierra

Sport™ 3R 9430R Printer. More information can be found in the

Operator’s Handbook

and

Programmer’s Manual

, included on the

CD-ROM.

Reading the LED

This table explains the LED indicators.

LED Indicators Status

Red or

Orange

The printer has an error and is not ready to

accept data.

The battery is charging at a fast rate. If the

battery voltage is below 5.0V, the battery is

“trickle” charged until the battery reaches

5.0V.

Amber

Off The battery is fully charged.

Green On

The printer is on and ready to accept data.

If there is no activity for longer than

20-30 seconds, the printer goes into sleep

mode to conserve the battery. The printer

“wakes up” when it receives any information

from the host or you press the power (P)

button.

With Bluetooth printers, the printer has a

mode where it can stay on all the time.

Installing the Battery

One battery may be included with the

printer. The printer’s battery must be

charged before using it.

1. Unlock the battery door by sliding

down the tabs using your thumbs.

2. Open the battery door.

LED Indicators

Summary of content (4 pages)

PAGE 1
QUICK REFERENCE Use this Quick Reference along with your Paxar Monarch Sierra Sport™ 3R 9430R Printer. More information can be found in the Operator’s Handbook and Programmer’s Manual , included on the CD-ROM. Reading the LED This table explains the LED indicators. LED Indicators LED Indicators Status Red or Orange On The printer has an error and is not ready to accept data. Amber On The battery is charging at a fast rate. If the battery voltage is below 5.
PAGE 2
3 . Insert the battery with contact end first. 4 . Close the battery door. 5 . Lock the battery door by sliding up the tabs. To remove the battery, partially open the battery door and tip out the battery. If the battery door is completely open, the hinge prevents the battery from falling out. Charging the Battery The printer’s battery must be charged before using it. The battery can be charged ♦ ♦ using the single or four-station charger. inside the printer using the plug-in charger for select printers.
PAGE 3
Connecting the Printer 1 . Plug your host into the printer’s RS232 port using a modular connector. 2 . Turn on the printer. 3 . Make sure the DIP switches are set to match the communication RS232 Port values on your host. Loading Supplies The printer can print text, bar codes, and some limited graphics on thermal direct receipt paper. 1 . Lift up the “T” lever on the supply door and wrap your fingers around it. 2 . Pull up firmly on the supply door to “T” Lever open it. 3 . Drop the supply into the well.
PAGE 4
Troubleshooting If you cannot fix a problem, call Technical Support. For optimal printer performance, we recommend cleaning the printer according to the directions found in the Operator’s Handbook . For supplies, service or assistance, call toll free: 1-800-543-6650 (in the U.S.A.). See our Web site (www.paxar.com) for additional information. Problem Action Does not feed or has a paper jam. Remove any jammed supplies. Reload supplies. Does not print. Check or replace the printer’s battery.