User guide

To check the battery:
The battery status flashes briefly
when you turn the printer on. If the
printer is already on, press A
under p. To return to Ready
mode, press the A under R.
To charge the battery:
1. Open the supply door and remove the
battery.
2. Insert the battery into the charger.
The Charging LED flashes and then
turns solid, starting the charging process.
The Complete LED turns solid when the
charging process is finished.
Sleep Mode
If configured to do so, the printer goes into sleep mode when it is inactive
for a period of time to conserve battery power. The printer displays a
coffee cup icon when it is in sleep mode. To wake the printer, press any
button except the power button (P). Or, continue normal data collection
terminal use.
Connecting the Communications Cable
1. Open the hinged cable door by loosening the screws and lifting up on
the door.
2. Plug the cable into the port.
3. Place the cable in the cable cavity.
4. Close the hinged cable door and
tighten the screws.
Loading Supplies
1. Open the supply door by pushing the release buttons down on both
sides of the printer. The supply door should swing open.
2. Remove the tape from a new roll of supply.
3. Apply pressure to the supply holder tabs (from the center outward) to
widen the supply holders. Insert a roll of supplies (Figure 1). Make
sure the supply unwinds from the top as shown. Feed the loose end
of the supply through the exit chute.
4. Pull out enough supply to lie across the exit chute (Figure 2).
For Non-Peel (Continuous) Mode:
5.
Close the supply door until the release buttons click into place
(Figure 3).
Figure 1 Figure 2 Figure 3
For Peel Mode:
6.
Remove a couple of labels from the liner. Feed the supply under the
peel bar. If the peel bar is not open, push up on the release buttons
on both sides of the printer (Figure 4).
7. Close the supply door until the release buttons click into place
(Figure 5). The peel bar closes when the supply door clicks into
place.
8. Press F once or twice to advance the labels and to calibrate the
supply under the printhead (Figure 6). The liner separates from the
label.
Figure 4 Figure 5 Figure 6