Printer Programmer's Manual

Field Contents
L## Must begin with the letter ’L’ for a line field.
The L is followed by one or two digits for the field number.
There can be up to 100 fields per format, in any combination
of text, barcode, line, or graphic fields.
Values: 0-99
ROW One to four digits to define the row location of the field on the
supply. This is the distance from the the guide edge zero
point at the bottom of the supply and the bottom of the field.
The zero point is 1.5 mm or 0.060 inches from the bottom of
the supply. The bottom of the supply is the edge that exits the
printer first.
This value is measured in tenths of millimeters (TOMMS) and
must be less than the maximum length of the supply.
Values: 0-2032
COLUMN One to four digits to define the column location of the field on
the supply. This is the distance from the guide edge zero
point at the left edge of the supply and the left edge of the
field.
The zero point is 1.5 mm or 0.060 inches from the left edge of
the supply.
The unit of measurement is tenths of millimeters. The range
must be less than the maximum width of the supply.
Values: 0-1016 (0 to 4 inches)
DIRECTION One digit to define the direction of the line.
Values: 0 = Vertical
1 = Horizontal
STOP One to four digits to define the stop position (Row or Column,
dependent on the DIRECTION setting) for the line.
Values: 1-2032
THICKNESS One or two digits for the line thickness in dots. 1 dot = 1/192
inch
Values: 1-15
Message Structures 3-17