Printer Operator's Manual

05/08 Rev. AB OPERATOR’S HANDBOOK Getting Started
9844/9854
1-3
Printer Contents
After you unpack your printer, make sure you have all the necessary
components and that the printer was not damaged during shipping.
• Printer
• Power supply cable
The plug for the power supply is different depending on the country of
delivery.
• Data cable
Centronics IEEE 1284 CA Cable 2 m.
• Core adapters
There are two core adapters each for the material rolls with a internal core
diameter of 3 inches (76mm) and 4 inches (101 mm). The core adapters are
placed on the printer material dispenser.
• Empty foil core
For rewinding the ribbon (foil). The backing paper is placed on foil rewind
reel.
• Operator’s Handbook
• Size 10 Torx screwdriver
Used to replace the print roller and add a dispensing (peel) edge.
9854 with
Internal Liner
Takeup Reel
• 9854 printer with installed deflector
• Housing front part, bottom side with screw (Fig. 3 right side)
¯ Use the housing parts if the printer does not have the internal liner takeup
reel (rewinder).
Fig. 3: These housing parts are shipped loose with the printer with internal liner takeup.
Removing the Transportation Lock
1. Open the cover.
2. Remove the two foam pads holding the printhead in place.
9854 with
Dispenser
« Remove the connector from its transport position at the printer bottom and
connect it to the front of the printer.