User manual

14 • Printer Assembly Users Manual Model 545™
Configuration Number Two: Line voltage within the range of
(See 230VAC Fuse Placement) 180 - 265VAC @ 50 - 60Hz
1) Install two 990757 6.0A 250V Fast Acting 5 x 20MM
NOTE: The fuse jumper must be removed to install both 5 x 20mm fuses.
115VAC Fuse Placement 230VAC Fuse
Placement
The fuses must be between points A and B as shown, not B and C.
5 X 20MM Fuse Placement
5) Reinsert the fuse drawer into the AC entry with the desired voltage up.
6) Close the AC entry and verify the correct voltage is now visible.
Installing the Power Cord
A power cord is shipped with each printer. The cord for 115-volt printers will use
the standard three-prong plug used in the U.S.A. A 230-volt printer and some other
115-volt configurations will have the plug end of the cable removed. It is the
customer’s responsibility to have the plug alteration work done by a certified
electrician. Paxar supplies printers to many countries with many variations.
Therefore we leave this to the customer to make the proper selection for their
country.