User manual

18 • Printer Assembly Users Manual Model 545™
Print Module Handling
CAUTION: Do not lay the print module flat on the sides, back, or front if removed
from the printer. The unit must stand on end as shown below.
Installing the Stacker
Remove the stacker from the separate packaging. Remove the packaging from
around the stacker and save with the rest of the printer packing supplies. Swing
open the top cover to the printer. Make sure that the stacker bed is in the most
upright position by loosening the locking knob and rotating the bed up and then re
tightening the locking knob. Locate the clearance hole as shown below in the center
of the knife’s mounting bracket. Place the stacker into position by inserting the
screw in the stacker’s mounting plate into the clearance hole and making sure that
the stacker is resting on the two leveling pins. Using a 3/16” long handled ball
driver tighten the screw until the stacker is secured in place. Adjusting the stacker
position is covered later.
3/16” Lon
g
Handled Ball
Driver
Clearance
Hole