User manual

30 • Printer Operation / Adjustments Users Manual Model 545™
Stacker Label Length Adjustment
• Loosen the “T” head thumbscrews on either side of the upright base.
• Slide the entire base to the desired position so that the cut label hangs over the
last belt roller approximately ¼” (6mm)
Stacker Angle Adjustment
• Turn the lock knob counter-clockwise to allow the stack end of the stacker to
rotate.
• Once the stack is so that the stacker rails are approximately 5° to 30° off
horizontal, tighten the lock knob by turning it clock-wise.