User manual

Users Manual Model 545™ Control Panel Operation • 49
CALIBRATE SENSORS
PRESS ENTER TO
CAL I BRATE SENSORS
This screen follows the "PRINT HEAD CLEANING PROC" screen.
Pressing ENTER will take the user to the "CALIBRATE SENSORS" screens.
Pressing the MODE / Down Arrow key will take the user to the "LIFE
COUNTS/VERSIONS" screen. Pressing the EXIT / Up Arrow key will take the
user back to the "HOME" screen.
HOLE / SLOT I N SENSOR
VALUE:000 NEW VALUE:000
This screen is the first screen under "CALIBRATING SENSORS" screen. Place the
fabric hole/slot sense mark under the sensor. Slowly move the fabric under the
sensor until the NEW VALUE reading is its lowest value then press ‘Enter’.
Pressing the MODE / Down Arrow key will take the user to the "HOLE/SLOT NOT
IN SENSOR" screen. Pressing the EXIT / Up Arrow key will take the user back to
the "HOME" screen.
HOLE / SLOT NOT I N SENSOR
VALUE:000 NEW VALUE:000
This screen follows the "HOLE/SLOT IN SENSOR" screen. Place the fabric under
the sensor so that it blocks the sensor and when NEW VALUE is at its highest value
press ‘Enter’.
Pressing the MODE / Down Arrow key will take the user to the "TOP REFL OVER
MARK" screen. Pressing the EXIT / Up Arrow key will take the user back to the
"HOME" screen.
TOP REFL OVER MARK
VALUE:000 NEW VALUE:000
This screen follows the "HOLE / SLOT NOT IN SENSOR" screen. Place the fabric
under the top reflective sensor so that the reflective mark is under the sensor and
when NEW VALUE is at the highest value press ‘Enter’.
Pressing the MODE / Down Arrow key will take the user to the "TOP REFL NOT
OVER MARK" screen. Pressing the EXIT / Up Arrow key will take the user back
to the "HOME" screen.
TOP REFL NOT OVER MARK
VALUE:000 NEW VALUE:000
This screen follows the "TOP REFL OVER MARK" screen. Place the fabric under
the top reflective sensor so that the fabric is under the sensor but the reflective mark
is not under the sensor and when NEW VALUE is at the lowest value press ‘Enter’.
Pressing the MODE / Down Arrow key will take the user to the "BOT REFL OVER
MARK" screen. Pressing the EXIT / Up Arrow key will take the user back to the
"HOME" screen.