Operating Instructions Battery Charger 9460

ManualsBrandsPaxar ManualsBattery ChargerSierra Sport2 9460

OPERATING INSTRUCTIONS

The Monarch® 9465™ Four-Station Battery Charger

charges from one to four 7.4V lithium-ion batteries for the

following printers:

♦ Sierra Sport2™ 9460™

♦ Sierra Sport3™ 9433™

♦ Monarch® Pathfinder® Ultra® Silver 6032™

♦ Monarch® Pathfinder® Ultra® Gold 6037™

♦ Monarch® Pathfinder® Ultra® Platinum 6039™

Note: You must charge a battery before using it.

WARNINGS

♦ Use only a Monarch-qualified battery.

♦ The battery could be damaged or explode if placed on

a different charger.

♦ Do not throw the battery in the trash. Dispose

according to your local regulations.

♦ Do not disassemble, short-circuit, heat above 80°C, or

incinerate the battery. It may explode.

♦ Follow the operating and storage limit specifications

listed at the end of these instructions. Otherwise, the

battery may permanently lose its charge capacity.

Summary of content (4 pages)

PAGE 1
O P E R AT I N G I N S T R U C T I O N S The Monarch® 9465™ Four-Station Battery Charger charges from one to four 7.4V lithium-ion batteries for the following printers: ♦ Sierra Sport2™ 9460™ ♦ Sierra Sport3™ 9433™ ♦ Monarch® Pathfinder® Ultra® Silver 6032™ ♦ Monarch® Pathfinder® Ultra® Gold 6037™ ♦ Monarch® Pathfinder® Ultra® Platinum 6039™ Note: You must charge a battery before using it. WARNINGS ♦ Use only a Monarch-qualified battery.
PAGE 2
Connecting the Power Supply To connect the power supply: 1. Plug one end of the power supply into a wall electrical outlet. 2. Plug the other end of the power supply into the back of the charger. The Power LED is on when the charger is set up and plugged in.
PAGE 3
Charging a Battery To charge a battery, insert the battery into the charger as shown. Charging time can take up to three hours. It takes approximately two hours to reach the 80% level (where it is now usable). To reach 100%, it takes approximately one hour more. Reading the Display Once the charger is plugged into an electrical outlet, the Power LED is on (solid). There are four charging stations and each has its own set of LEDs.
PAGE 4
Troubleshooting When an error occurs, the Charging and Complete LEDs blink together. In this case, repeat the charging process. If the error still occurs, repeat the process with a new battery. If there is a problem after the second repeat charge, call Service. In between charges, remove the battery, wait for the lights to stop flashing, then re-insert the battery.