User's Manual

Caution

Do not touch the electrical connectors while setting up the printer. Electrostatic discharge can damage or

destroy the printhead or electronic components.

ALWAYS PLUG THE PRINTER INTO THE ELECTRICAL WALL OUTLET FIRST AND THEN TURN ON

THE PRINTER – NEVER TURN ON THE PRINTER AND THEN PLUG IT INTO THE WALL OUTLET.

*Setting Up the System

Follow these instructions to setup the printer,

keypad/terminal, and power supply in the tray.

1. Remove the tray and check inside the packaging for the

adhesive feet. Remove the feet from their adhesive

backing and apply one to each corner.

2. Place the tray on the cut table near an electrical outlet.

Tray design may vary from the one shown.

3. Make sure the power is off on both the printer and the

keypad/terminal before setting up any cables.

4. Facing the front of the tray, lay the serial cable (part

number 125802) behind the tray.

5. Plug the three-hole end of the printer’s power

supply cable into the three-pronged outlet in the

printer’s power supply.

6. Place the printer’s power supply behind the tray

with the printer’s connector on the right side.

7. Place the keypad/terminal’s power supply into the

tray under the shelf with the three-pronged end

facing the cut-out in the back of the tray.

8. Through the back of the tray, plug the three-hole

end of the keypad/terminal’s cable into the three-

pronged outlet in the keypad/terminal’s power

supply (18-24V).

9. Lay the keypad/terminal’s cable with the L-shaped

connector on the shelf.

10. Place the keypad/terminal on the shelf, but do not

remove the tape from the Velcro at this point.

Adhesive Feet

L-shaped connector

To printer

To keypad/terminal

Power cable Printer’s Power Power Cable

to Printer Supply to wall outlet

Keypad/Terminal’s

Power Supply

PAGE 1
*Setting Up the System Caution Do not touch the electrical connectors while setting up the printer. Electrostatic discharge can damage or destroy the printhead or electronic components. ALWAYS PLUG THE PRINTER INTO THE ELECTRICAL WALL OUTLET FIRST AND THEN TURN ON THE PRINTER – NEVER TURN ON THE PRINTER AND THEN PLUG IT INTO THE WALL OUTLET. Adhesive Feet Follow these instructions to setup the printer, keypad/terminal, and power supply in the tray. 1.
PAGE 2
The keypad/terminal should not be operated in a location that has room temperatures above 158° F or below -4° F for extended periods of time. This could permanently damage the display. Make sure the printer’s power supply is not accidentally connected to the keypad/terminal. 11. Plug the L-shaped connector into the socket located on the top of the keypad/terminal (12V). 12. Connect the serial cable to the top of the keypad/terminal. L-shaped Connector Serial Cable 13. Place the printer in the tray.