User's Manual

Page 6
Adding proximity tokens
Present the Master Token
The RED and GREEN LEDs flash simultaneously indicating reader is in
Programming Mode
Up to 2000 proximity tokens can be added to the keypad. Each token is allocated to a memory slot on the keypad.
A note will need to be made of the memory slot a token is allocated to, a handy table is included in these instructions
for this purpose. To add a proximity token to the reader do the following:
Press
to exit
programming
mode
Press Press
Re-enter
memory
slot number
Present proximity
token to
the keypad
Enter
memory
slot number
Press
1
or
2
or
3
Adding proximity plus PIN tokens
For additional security, you may wish a user to enter a PIN (personal identification number) as well as present a proximity
token, in order to open the door. To configure a token to require PIN entry as well, do the following:
Present the Master Token
The RED and GREEN LEDs flash simultaneously indicating reader is in
Programming Mode
Press
to exit
programming
mode
Press Press
Re-enter
memory
slot number
Press Press
Re-enter
PIN
Present proximity
token to
the keypad
Enter
memory
slot number
Enter PIN
Press

or

or

Barring proximity tokens
If a proximity token has been lost, or you no longer wish the user to gain entry, the proximity token can easily be removed
from the system. To remove a user token, do the following:
Present the Master Token
The RED and GREEN LEDs flash simultaneously indicating reader is in
Programming Mode
Press
to exit
programming
mode
Press Press Press
Re-enter
memory
slot number
Enter
memory
slot number
