User Manual
PAGE 3
Reader installation and test
Following the completed installation of this equipment, no further maintenance or testing is required.
It is advisable to ensure that any third party backup power supplies or recovery procedures are checked regularly
to ensure that the operation of the Paxton system is not compromised.
Maintenance
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. Changes or modications not expressly
approved by the party responsible for compliance could void the user's authority to operate the equipment.
Drill a hole in the surface for the rear data cable. Secure the mounting plate to the surface with four screws as per
tting diagram on page 1. Suitable screws and xings are provided for tting the plate to a wall.
Mount the reader on its backplate and secure with the security screws using the Allen key supplied. Ensure the
data cable has free access at the rear.
The reader will bleep and all the LEDS should display after powering on the control unit. Presenting a user card to
the reader will cause the LEDs to briey change to a single Green or Red LED.
Check the following FAQs section for assistance if any problems are encountered.
Parts list
Part number Description
Fitting Kit fk1-058 4 off - M5x20 Security button socket pin head machine screw
4 off - No8 x 1
1
/2in pozi round woodscrew - zinc
4 off - Wall plugs 35mm, red
1 off - 3mm socket pin head Allen key
The use of any add-on, expansion, memory or other module manufactured or supplied by the manufacturer's
representative will invalidate the CAN/ULC-S319 certication.
For CAN/ULC-S319 installations, terminals, leads and wiring methods must comply with CSA, C22.1, Canadian
electrical code, Part 1, safety standards for electrical installations.
Product compliance and limitations
To comply as a UL listed installation, the following conditions must apply:-
Server based functions (Antipassback, Time and Attendance, etc) have not been evaluated by UL and cannot be used
for UL 294 installations.
The use of Wiegand readers and the conguration software has not been evaluated by 'UL'
Wiring: - Where an equivalent cable / wire is used it must be ' UL Listed '
All interconnecting devices must be UL Listed.
Wiring methods shall be in accordance with the National Electrical Code (ANSI/NFPA70), local codes, and the
authorities having jurisdiction.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.