User's Manual
Once all the ACUs have been tested and the Net2 nano powered up, the Net2Air bridges need to be congured.
A USB Net2Air bridge will be registered by the Net2 software automatically. This displays in the Net2 Server
Conguration Utility/Net2Air bridge as a xed IP entry.
Software installation
To register an Ethernet Net2Air bridge, click on Detect and setup the IP addresses as required.
See also:X Ins-30085-US Net2Air Ethernet bridge < http://paxton.info/1192 >
Radio frequency
If you are experiencing problems with the range or reliability this may be due to poor nano / bridge positioning.
The unit is set to channel 11 (2.405 GHz) as this frequency is normally clear of other device transmissions.
Technical support can advise if you are concerned about interference from adjacent radio based (WiFi) equipment.
This product is not suitable for retail sale. All warranties are invalid if this product is not installed by a competent person.