Specifications

e l b a e g r a h c e R d e l a e S

B a tte r y

h A 7 V 2 1

V 2 1

V 0

V 2 1

V 0

V 2 1

V 0

U S P

V 0

INPUT A C 100-240V

50 / 60 Hz

1.2A

OUTPUT DC 13.8V 2A

Ins-30039-US

2A/12V DC boxed power supply with Net2 ACU

04/15/2011

Technical help is available: Monday - Friday from 02:00 AM - 8:00 PM (EST)

1.800.672.7298 support@paxton-access.com

Technical Support

Paxton Net2

control unit

Back-up battery

AC INPUT

Tamper switch

Layout

12V DC Outputs

NOTE: Ratings Label

AC Input Failure Monitoring

NOTE: The Tamper switch type and position will vary due to the different case styles.

Documentation on all Paxton products can be found on our web site - http://www.paxton-access.com/

Paxton

Green

Red

This LED is on when the input supply has failed - Power is being supplied by the battery.

This LED is on when the input supply is healthy.

Status Lights

PAGE 1
04/15/2011 Ins-30039-US 2A/12V DC boxed power supply with Net2 ACU Paxton Technical Support 1.800.672.7298 support@paxton-access.com Technical help is available: Monday - Friday from 02:00 AM - 8:00 PM (EST) Documentation on all Paxton products can be found on our web site - http://www.paxton-access.com/ Layout 0V 0V PSU 0V 12V 0V 12V 12V 12V DC Outputs AC Input Failure Monitoring Paxton Net2 control unit INPUT OUTPUT AC 100-240V 50 / 60 Hz 1.2A DC 13.
PAGE 2
Mounting 1 in 4 5/8 in 1. Screws and wall plugs are provided in a parts kit. With reference to the diagrams, determine where the top, central mounting hole is required and drill a hole suitable for a No 8 wall plug. 2. Tap in one of the wall plugs. 3. Put in one of the long screws, leaving a suitable gap to the wall surface in order to slot the cabinet over it. 12 5/8 in 4. Mark the hole positions for the lower 2 screws. 5. Remove the cabinet and drill the additional holes. Metal Cabinet 10 1/2 in 6.
PAGE 3
Features Battery backup The cabinet can accommodate a 12V / 7Ah battery. Fast/Trickle charge The battery is continuously charged to keep it at maximum capacity. Deep discharge protection If battery voltage falls below 9.5V, it will automatically disconnect - Red Led goes out AC supply failure (PSU) Registers an alarm if the AC input power fails when connected to an ACU or I/O board. Tamper alarm Registers an alarm if the lid is opened when connected to an ACU or I/O board.