Owner's manual

ManualsBrandsPaxton ManualsFor HomeI/O board with 2A/12V DC boxed power supply

e l b a e g r a h c e R d e l a e S

B a tte r y

h A 7 V 2 1

V 2 1

V 0

V 2 1

V 0

V 2 1

V 0

U S P

V 0

+12V

r e w o P s t u p n I

2 r e d a e R 1 r e d a e R

Red

Brown

Orange

Green

Yellow

Blue

Mauve

Black

Red

Brown

Orange

Green

Yellow

Blue

Mauve

Black

Relay 1 Relay 2 Relay 3 Relay 4

INPUT AC 100-240V

Model No: 411-xxx

Read installation instructions

before connecting the supply

50 / 60 Hz

1.2A

INPUT AC 100-240V

Model No: 411-***

Read installation instructions

before connecting the supply

50/60Hz, 1.2A

OUTPUT DC 13.8V, 2A

PSU Ratings:

Paxton I/O control board

Back-up battery

PSU

MAINS POWER

28/06/2012

Tamper Switch

Layout

Mains Monitoring

12V DC Outputs

Ratings Label

Ins-30043 I/O board with 2A/12V DC boxed power supply

Technical Support

Technical help is available: Monday - Friday from 07:00 - 19:00 (GMT)

Saturday from 09:00 - 13:00 (GMT)

01273 811011 support@paxton.co.uk

Documentation on all Paxton products can be found on our website - http://www.paxton.co.uk/

Paxton

Summary of content (3 pages)

PAGE 1
28/06/2012 Ins-30043 I/O board with 2A/12V DC boxed power supply Paxton Technical Support 01273 811011 support@paxton.co.uk Technical help is available: Monday - Friday from 07:00 - 19:00 (GMT) Saturday from 09:00 - 13:00 (GMT) Documentation on all Paxton products can be found on our website - http://www.paxton.co.
PAGE 2
5 mm 116 mm Fitting 1. Screws and wall plugs are provided in a fitting kit. With reference to the diagrams, determine where the top, central mounting position is required and drill a hole suitable for a No 8 wall plug. 2. Tap in one of the wall plugs. 320 mm 3. Put in one of the long screws, leaving a suitable gap to the wall surface and slide the cabinet over it. 4. Mark the hole positions for the lower 2 screws. 268 mm Metal Cabinet 5. Remove the cabinet and drill the additional holes. 6.
PAGE 3
Status Lights Green This LED is on when the input supply is healthy. Red This LED is on when the input supply has failed - Power is being supplied by the battery. Features Battery backup The cabinet can accommodate a 12V / 7Ah battery. Fast/Trickle charge The battery is continuously charged to keep it at maximum capacity. Deep discharge protection If battery voltage falls below 9.5V, it will automatically disconnect - Red LED goes out.