25/03/2010 Paxton Ins-30041 Magstripe 1000 kit Technical Support 01273 811011 support@paxton.co.uk Technical help is available: Monday - Friday from 07:00 - 19:00 (GMT) Saturday from 09:00 - 13:00 (GMT) Documentation on all Paxton products can be found on our website - http://www.paxton.co.
Installation Fitting the reader Step 1: Carefully mark out the mounting holes for the reader and the hole of the cable feed. Step 2: Drill the marked holes for the mounting points and the cable feed. When drilling the holes, ensure that you are aware of any hidden cables or pipes. Once the holes have been drilled, fit the supplied wall plugs and feed the cable through the cable feed hole before securing the reader to the wall using the screws supplied.
This Magstripe kit contains the following items. If you find that any of the parts are missing or damaged, please notify your supplier. x1 x1 x1 x1 d e on s nam user’ er, then the ad write the re er rd, r ca through e read se the u th it rd, la ipe ugh is ca , enro , sw thro od e th 1. To r card r card swip ed peri . pe a pa the use time, quir stop e open r the re ng will swip or fo pi do wait the blee the set ep, , 2.
Programming the system Adding the card pack 2 1 3 ! EP BE P! BEE on e m n na he ’s , t er er he us ead r e ,t r th he ade rd t re ca od, ite i is wr ugh e th per p. d, hro h th o e r t ip ed s ca t t ug sw uir ill er e i hro e, req g w t us ip tim he pin l a sw card ro d, en r t lee en car ser op it fo e b o r u r h T e e a o t 1. pap th do , w in, he ep ga a ipe t t be a sw se ill ard To r w e c 2. ade th re ipe sw rd a rC te as M 1. 2. 3. 4.
Unbarring user cards 2 3 4 rd hn ca 33 45 96 na m e: ip e Jo th i s 1. 2. 3. 4. 33 Sw 54 W rit e 22 Sm ith to ba r: 1 Swipe bar: cardtotobar: thiscard Swipethis Swipe bar: tobar: cardto thiscard Swipethis Smith John Write name: Smith John Write name: John Smith Write name: John Smith Write name: 77 88 If a barred user card is found, it can be re-validated on the system. Find the matching shadow card. Swipe this card through the reader and return it to storage.
To delete a card pack 1. Card packs may be deleted from the system if required. Once a card pack has been deleted another one may be enrolled in its place. 2. To delete a card pack, take the master card and swipe it backwards through the reader. The LEDs should then start to flash in sequence, one after the other. 3. During this phase, swipe the master card backwards again and the reader will bleep once and the LEDs will all come back on. 4.
