Specifications

Ins-30175 Net2Air Ethernet bridge in plastic housing

05/07/2012

Technical Support

Technical help is available: Monday - Friday from 07:00 - 19:00 (GMT)

Saturday from 09:00 - 13:00 (GMT)

01273 811011 support@paxton.co.uk

Software - Requires Net2 v4.14 or later.

Documentation on all Paxton products can be found on our website - http://www.paxton.co.uk/

The access control unit connects to the Net2 system using Paxton Net2Air proprietary wireless technology through

a Net2Air bridge.

Radio signals do not always behave as you might expect. For example, a mobile phone that displays a full signal

on one part of the site will lose signal completely only a few metres away. These problems can be addressed by

using the Net2 site surveyor kit (690-200).

See also: XAN1095 - Net2 wireless access control - How does it work? < http://paxton.info/974 >

X AN1096 - How to plan a Net2 wireless installation < http://paxton.info/975 >

X Ins-30096 - Net2Air site surveyor < http://paxton.info/1015 >

Net2Air wireless communication

Enclosure

Paxton

Radio frequency

This product should not be installed within 3 metres of other wireless equipment operating on a 2.4Ghz frequency.

To ensure optimum performance other wireless networks should avoid WiFi channels 1, 2 and 3 to reduce the

possibility of interference.

Net2Air Site Surveyor (690-200).

This access control unit uses wireless communication. It is recommended that a Net2Air site surveyor is used

to determine the best position for the bridge and control units.

PAGE 1
05/07/2012 Ins-30175 Net2Air Ethernet bridge in plastic housing Technical Support 01273 811011 Technical help is available: Paxton support@paxton.co.uk Monday - Friday from 07:00 - 19:00 (GMT) Saturday from 09:00 - 13:00 (GMT) Documentation on all Paxton products can be found on our website - http://www.paxton.co.uk/ Enclosure Software - Requires Net2 v4.14 or later.
PAGE 2
Connecting to the PC via the Ethernet port The IP address should be assigned a fixed value, or should be given a DHCP reservation. Unreserved IP addresses issued by DHCP servers are not guaranteed to be constant, leading to potential failure of communication between Net2 software and the bridge. Run the Net2 Server Configuration Utility (Start/Programs/Net2) and Click on Net2Air Bridge. Click on;Detect and the MAC address of the device(s) will appear in the table.
PAGE 3
LED indications Power Reset button Power LED Server Connected - The TCP/IP interface is communicating with the PC Net2 server TCP/IP LAN connection Net2Air wireless activity (Tx/Rx) - Blue Data Reset To clear all settings back to their factory default, including clearing the current IP address and setting the bridge to acquire new addresses using DHCP, power on the unit with the reset button held down for 3 seconds. The unit will beep to acknowledge once the reset is complete.