4/11/2011 Ins-30042 - OEM Reader keypad kit Suitability Wet environments Mounted on metal surface Security-sensitive doors Readers mounted together 300mm between readers Fitting Gre y Black Exit button (push to make) 9-15V DC te hi W +12V DC (fuse rating 1A) - + * 0V 12V DC release current rating must be less than 1A. * The diode current rating must be equal to or greater than the current required to drive the release. User cards are NOT supplied with this unit.
Please read the following notes before installing Electrical shock can cause injury or death. Remove all power before making any electrical connections, performing maintenance or repair. Mains electrical connections should be made only by qualified personel in accordance with local regulations. Safety goggles should be worn while using power tools. In this kit you will find the following items. If you find that any of the parts are missing or damaged, please notify your supplier.
Fitting the keypad Step 1: Carefully mark out the mounting holes for the keypad and the hole of the cable feed. Step 2: Drill the marked holes for the mounting points and the cable feed. When drilling the holes, ensure that you are aware of any hidden cables or pipes. Once the holes have been drilled, fit the supplied wall plugs and feed the cable through the cable feed hole before securing the reader to the wall using the screws supplied.
Setting The Master Code The first time the keypad is turned on the RED and GREEN LEDs flash alternately. This indicates a 6 digit Master Code must now be entered. »The Master Code allows access to the Programming Menu.
Changing the keypad backlight Enter 6 digit Master Code The RED and GREEN LEDs flash simultaneously indicating reader is in Programming Mode Press and hold for 3 seconds 0 { *# } = On press = Off Setting multiple entry codes (maximum = 120) Press # = default to exit programming mode Enter 6 digit Master Code The RED and GREEN LEDs flash simultaneously indicating reader is in Programming Mode Press and hold for 3 seconds 2 { *# } = On press = Off Press # to exit programming mode When in Mu
Setting the keypad for additional security Enter 6 digit Master Code The RED and GREEN LEDs flash simultaneously indicating reader is in Programming Mode { *# } Press and hold for 3 seconds 4 = On Press # press = Off to exit programming mode When enabled, the keypad will deactivate for 60 seconds if there are 20 consecutive incorrect numbers entered = default Changing the Master code Enter 6 digit Master Code The RED and GREEN LEDs flash simultaneously indicating reader is in Programming Mode
Adding proximity tokens Up to 2000 proximity tokens can be added to the keypad. Each token is allocated to a memory slot on the keypad. A note will need to be made of the memory slot a token is allocated to, a handy table is included in these instructions for this purpose.
Technical Help Here is the list of topics about this product that receive the most technical support enquiries. We list them here to help you speed up the installation and trouble shooting process. 1. I have connected the keypad correctly. Why doesn't it open when I enter my code? QQ QQ QQ- Check that there is power to the keypad by setting the keypad backlight to ON, and listening for keypad beeps. If not, check the power supply. Check that the green light flashes when the correct code is entered.
Page 9
