Installation Manual

Microfence Installation Manual 15
To satisfy RF exposure requirements, this device and its antenna must operate
with a separation distance of at least 20 cm from all persons.
Changes or modifications not expressly approved by Paycom Software Inc.
could void the user's authority to operate the equipment.
Per RSS-Gen, Section 8.4 This device
complies with Industry Canada license-
exempt RSS standard(s). Operation is
subject to the following two
conditions: (1) this device may not
cause interference, and (2) this device
must accept any interference, including
interference that may cause undesired
operation of the device.
Selon RSS-Gen, Section 8.4 Cet appareil
est conforme aux normes RSS sans
licence d'Industrie Canada. Son
fonctionnement est soumis aux deux
conditions suivantes : (1) cet appareil
ne doit pas provoquer d'interférences,
et (2) cet appareil doit accepter toute
interférence, y compris les
interférences pouvant provoquer un
fonctionnement indésirable de
l'appareil.
This device contains license-exempt
transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic
Development Canada’s license-exempt
RSS(s). Operation is subject to the
following two conditions:
1. This device may not cause
interference.
2. This device must accept any
interference, including
interference that may cause
undesired operation of the
device.
Cet appareil contient des
émetteurs/récepteurs exempts de
licence qui sont conformes aux RSS
exemptés de licence d'Innovation,
Sciences et Développement
économique Canada. L'exploitation est
soumise aux deux conditions suivantes
:
1. Cet appareil ne doit pas provoquer
d'interférences.
2. Cet appareil doit accepter toute
interférence, y compris les
interférences susceptibles de
provoquer un fonctionnement
indésirable de l'appareil.