Installation Manual

4 Microfence Installation Manual
The bottom view shows the wall mount, which is removable by
pressing the release tabs.
Figure 2 - Bottom View
Choosing Installation Location
The Microfence beacon should be placed wherever you want
employees to clock in or out. When in operation the unit will
transmit a Bluetooth signal periodically that can be received by
the Paycom app on employees’ cellphones.
The beacon should be mounted on a wall or other surface.
Ideally, it should be mounted high on an inside wall in a large,
open area, such as a building lobby, breakroom, or similar
location where employees may congregate when clocking-in or
clocking-out.
Since the beacon uses RF technology its range will be improved
if the area has few obstructions to block the RF path.
Removing Wall Mount
The wall mount must be removed to insert batteries or to
attached it to a wall with screws. To release the wall mount
from the beacon:
1. Press the two release tabs on the bottom as shown in
Figure 3.
2. Pivot the wall mount upward as shown.
Power Jack
Release Tabs
Wall Mount
Beacon