Maintenance Guide

Cobham Wireless
idDAS Installation and Maintenance Guide 00109GU Rev. 2.0
Page | 83
To connect the CPRI cable from to the repeater CPRI port
1
. Unscrew the protective cylinder on the CPRI
port(s) and set the cylinder and the
accompanying sponge aside.
2
. If not inserted, insert the SFP module in the
CPRI port.
Figure 5-24. Remove Cylinder
3
. Route the optic fibre
through the cylinder and
press into the rubber seal.
Figure 5-25. Press Fiber in Rubber Seal
4
. Connect the CPRI connector to the repeater
MAIN or AUX1 CPRI port according to your
topology.
5
.
Screw the protective cylinder back around the
CPRI port and fit the rubber
inside to minimize
the entry of any dirt, dust or dampness.
Figure 5-26. Fibre Connection
Cylinder
Rubber
CPRI