Maintenance Guide

Cobham Wireless
idDAS Installation and Maintenance Guide 00109GU Rev. 2.0
Page | 91
x Pin-9 and Pin-10 can be respectively used as an internal 15 Vdc power source and as a chassis
ground source.
x Each connected alarm must be configured via the idDAS web management according to its trigger:
Active High or Active Low (Section 5.7.1.3). This step is also described as part of the commissioning
procedures in the idDAS Commissioning Guide.
x It takes about 10 sec to activate an alarm.
Figure 5-34: Dry Contact Alarms Pinout and Connection Example